[PATCH] ARM: msm: rename two Kconfig macros

[pebolle@tiscali.nl (Paul Bolle)]

Commit 650e3f0d66ade2a614d854765dae3bbc9a87f58d ("ARM: msm: Consolidate
and move DEBUG_LL to DEBUG_LL choice") renamed the Kconfig symbols
MSM_DEBUG_UART1, MSM_DEBUG_UART2, and MSM_DEBUG_UART3 to
DEBUG_MSM_UART1, etc. It also added some references to
CONFIG_DEBUG_MSM_UART1, etc. It did not, however, rename the two
existing references to CONFIG_MSM_DEBUG_UART1 and
CONFIG_MSM_DEBUG_UART3. Do so now.

Signed-off-by: Paul Bolle <pebolle@tiscali.nl>
---
0) Untested.

1) Would there actually be a readable way to write this commit
explanation? This explanation even confuses me! I guess it's just a
confusing matter.

 arch/arm/mach-msm/board-trout-gpio.c | 2 +-
 arch/arm/mach-msm/board-trout.c      | 2 +-
 2 files changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/arm/mach-msm/board-trout-gpio.c b/arch/arm/mach-msm/board-trout-gpio.c
index 87e1d01..a92efc8 100644
--- a/arch/arm/mach-msm/board-trout-gpio.c
+++ b/arch/arm/mach-msm/board-trout-gpio.c
@@ -94,7 +94,7 @@ static int trout_gpio_to_irq(struct gpio_chip *chip, unsigned offset)
 	}
 
 static struct msm_gpio_chip msm_gpio_banks[] = {
-#if defined(CONFIG_MSM_DEBUG_UART1)
+#if defined(CONFIG_DEBUG_MSM_UART1)
 	/* H2W pins <-> UART1 */
 	TROUT_GPIO_BANK("MISC2", 0x00,   TROUT_GPIO_MISC2_BASE, 0x40),
 #else
diff --git a/arch/arm/mach-msm/board-trout.c b/arch/arm/mach-msm/board-trout.c
index 919bfa3..02e0dd7 100644
--- a/arch/arm/mach-msm/board-trout.c
+++ b/arch/arm/mach-msm/board-trout.c
@@ -89,7 +89,7 @@ static void __init trout_map_io(void)
 	msm_map_common_io();
 	iotable_init(trout_io_desc, ARRAY_SIZE(trout_io_desc));
 
-#ifdef CONFIG_MSM_DEBUG_UART3
+#ifdef CONFIG_DEBUG_MSM_UART3
 	/* route UART3 to the "H2W" extended usb connector */
 	writeb(0x80, TROUT_CPLD_BASE + 0x00);
 #endif
-- 
1.7.11.7