From mboxrd@z Thu Jan 1 00:00:00 1970 From: tpiepho@gmail.com (Trent Piepho) Date: Tue, 2 Apr 2013 05:19:50 -0700 Subject: [PATCH V2 07/12] spi/mxs: Remove bogus setting of ssp clk rate field In-Reply-To: <1364905195-24286-1-git-send-email-tpiepho@gmail.com> References: <1364905195-24286-1-git-send-email-tpiepho@gmail.com> Message-ID: <1364905195-24286-7-git-send-email-tpiepho@gmail.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org The ssp struct has a clock rate field, to provide the actual value, in Hz, of the SSP output clock (the rate of SSP_SCK) after mxs_ssp_set_clk_rate() is called. It should be read-only, except for mxs_ssp_set_clk_rate(). For some reason the spi-mxs driver decides to write to this field on init, and sets it to the value of the SSP input clock (clk_sspN, from the MXS clocking block) in kHz. It shouldn't be setting the value, and certainly shouldn't be setting it with the wrong clock in the wrong units. Signed-off-by: Trent Piepho Cc: Marek Vasut Cc: Fabio Estevam Cc: Shawn Guo --- drivers/spi/spi-mxs.c | 1 - 1 file changed, 1 deletion(-) diff --git a/drivers/spi/spi-mxs.c b/drivers/spi/spi-mxs.c index 208de97..103c478 100644 --- a/drivers/spi/spi-mxs.c +++ b/drivers/spi/spi-mxs.c @@ -591,7 +591,6 @@ static int mxs_spi_probe(struct platform_device *pdev) clk_prepare_enable(ssp->clk); clk_set_rate(ssp->clk, clk_freq); - ssp->clk_rate = clk_get_rate(ssp->clk) / 1000; stmp_reset_block(ssp->base); -- 1.7.10.4