From mboxrd@z Thu Jan 1 00:00:00 1970 From: florian@openwrt.org (Florian Fainelli) Date: Thu, 4 Apr 2013 12:27:13 +0200 Subject: [PATCH 3/5 v2] ARM: kirkwood: add device node entries for the gigabit interfaces In-Reply-To: <1365071235-11611-1-git-send-email-florian@openwrt.org> References: <1365071235-11611-1-git-send-email-florian@openwrt.org> Message-ID: <1365071235-11611-4-git-send-email-florian@openwrt.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org This patch modifies kirkwood.dtsi to specify the various gigabit interfaces nodes available on kirkwood devices. They are disabled by default and should be enabled on a per-board basis. egiga0 and egiga1 aliases are defined for convenience. The mdio node is also present and should be enabled on a per-board basis as well. Signed-off-by: Florian Fainelli --- Changes since v1: - dropped change to arch/arm/mach-kirkwood/common.c to avoid merge conflicts - fixed off-by 0x2000 ethernet-group nodes address arch/arm/boot/dts/kirkwood.dtsi | 46 +++++++++++++++++++++++++++++++++++++++ 1 file changed, 46 insertions(+) diff --git a/arch/arm/boot/dts/kirkwood.dtsi b/arch/arm/boot/dts/kirkwood.dtsi index fada7e6..254f5a8 100644 --- a/arch/arm/boot/dts/kirkwood.dtsi +++ b/arch/arm/boot/dts/kirkwood.dtsi @@ -7,6 +7,8 @@ aliases { gpio0 = &gpio0; gpio1 = &gpio1; + egiga0 = &egiga0; + egiga1 = &egiga1; }; intc: interrupt-controller { compatible = "marvell,orion-intc", "marvell,intc"; @@ -202,5 +204,49 @@ clocks = <&gate_clk 4>; status = "disabled"; }; + + mdio at 72004 { + #address-cells = <1>; + #size-cells = <0>; + compatible = "marvell,orion-mdio"; + reg = <0x72004 0x84>; + status = "disabled"; + }; + + ethernet-group at 72000 { + #address-cells = <1>; + #size-cells = <0>; + compatible = "marvell,mv643xx-eth-block"; + reg = <0x72000 0x4000>; + tx-csum-limit = <1600>; + status = "disabled"; + + egiga0: egiga0 at 0 { + device_type = "network"; + compatible = "marvell,mv643xx-eth"; + reg = <0>; + interrupts = <11>; + clocks = <&gate_clk 0>; + clock-names = "0"; + }; + }; + + ethernet-group at 76000 { + #address-cells = <1>; + #size-cells = <0>; + compatible = "marvell,mv643xx-eth-block"; + reg = <0x76000 0x4000>; + tx-csum-limit = <1600>; + status = "disabled"; + + egiga1: egiga1 at 0 { + device_type = "network"; + compatible = "marvell,mv643xx-eth"; + reg = <0>; + interrupts = <15>; + clocks = <&gate_clk 19>; + clock-names = "1"; + }; + }; }; }; -- 1.7.10.4