From mboxrd@z Thu Jan 1 00:00:00 1970 From: florian@openwrt.org (Florian Fainelli) Date: Thu, 4 Apr 2013 12:27:15 +0200 Subject: [PATCH 5/5 v2] ARM: dove: add gigabit device tree nodes to dove.dtsi In-Reply-To: <1365071235-11611-1-git-send-email-florian@openwrt.org> References: <1365071235-11611-1-git-send-email-florian@openwrt.org> Message-ID: <1365071235-11611-6-git-send-email-florian@openwrt.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org This patch adds the gigabit ethernet device tree nodes to dove.dtsi in a disabled state. The gigabit ethernet device tree node must be enabled on a per-board basis. For completeness and easier testing the MDIO node is also added in a disabled state. Signed-off-by: Florian Fainelli --- Changes since v1: - fixed off-by 0x2000 address of the ethernet-group node arch/arm/boot/dts/dove.dtsi | 25 +++++++++++++++++++++++++ 1 file changed, 25 insertions(+) diff --git a/arch/arm/boot/dts/dove.dtsi b/arch/arm/boot/dts/dove.dtsi index f7509ca..51de5f7 100644 --- a/arch/arm/boot/dts/dove.dtsi +++ b/arch/arm/boot/dts/dove.dtsi @@ -253,5 +253,30 @@ dmacap,xor; }; }; + + mdio at 72004 { + #address-cells = <1>; + #size-cells = <0>; + compatible = "marvell,orion-mdio"; + reg = <0x72004 0x84>; + status = "disabled"; + }; + + ethernet-group at 72000 { + #address-cells = <1>; + #size-cells = <0>; + compatible = "marvell,mv643xx-eth-block"; + reg = <0x72000 0x4000>; + tx-csum-limit = <1600>; + status = "disabled"; + + egiga0: ethernet at 0 { + device_type = "network"; + compatible = "marvell,mv643xx-eth"; + reg = <0>; + interrupts = <29>; + clocks = <&gate_clk 2>; + }; + }; }; }; -- 1.7.10.4