From mboxrd@z Thu Jan 1 00:00:00 1970 From: lee.jones@linaro.org (Lee Jones) Date: Thu, 18 Apr 2013 11:26:59 +0100 Subject: [PATCH 3/9] ARM: ux500: Stop passing Hash DMA channel config information though pdata In-Reply-To: <1366280825-31136-1-git-send-email-lee.jones@linaro.org> References: <1366280825-31136-1-git-send-email-lee.jones@linaro.org> Message-ID: <1366280825-31136-4-git-send-email-lee.jones@linaro.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org DMA channel configuration information should be setup in the driver. The Ux500 Hash driver now does this, so there's no need to send it though here too. Signed-off-by: Lee Jones --- arch/arm/mach-ux500/board-mop500.c | 4 ---- 1 file changed, 4 deletions(-) diff --git a/arch/arm/mach-ux500/board-mop500.c b/arch/arm/mach-ux500/board-mop500.c index 883dc66..cb7ae23 100644 --- a/arch/arm/mach-ux500/board-mop500.c +++ b/arch/arm/mach-ux500/board-mop500.c @@ -473,11 +473,7 @@ static struct cryp_platform_data u8500_cryp1_platform_data = { static struct stedma40_chan_cfg u8500_hash_dma_cfg_tx = { .dir = STEDMA40_MEM_TO_PERIPH, .dev_type = DB8500_DMA_DEV50_HAC1_TX, - .src_info.data_width = STEDMA40_WORD_WIDTH, - .dst_info.data_width = STEDMA40_WORD_WIDTH, .mode = STEDMA40_MODE_LOGICAL, - .src_info.psize = STEDMA40_PSIZE_LOG_16, - .dst_info.psize = STEDMA40_PSIZE_LOG_16, }; static struct hash_platform_data u8500_hash1_platform_data = { -- 1.7.10.4