From mboxrd@z Thu Jan 1 00:00:00 1970 From: maxime.ripard@free-electrons.com (Maxime Ripard) Date: Thu, 13 Jun 2013 15:43:43 +0200 Subject: [PATCH 2/4] ARM: cfa10049: Switch the chip select pin of the LCD controller In-Reply-To: <1371131025-12200-1-git-send-email-maxime.ripard@free-electrons.com> References: <1371131025-12200-1-git-send-email-maxime.ripard@free-electrons.com> Message-ID: <1371131025-12200-3-git-send-email-maxime.ripard@free-electrons.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org From: Brian Lilly The early prototypes had the chip select pin for the LCD controller wired on the GPIO 3-23, while the production run of the CFA-10049 have this chip select on the GPIO 3-5. Signed-off-by: Brian Lilly Signed-off-by: Maxime Ripard --- arch/arm/boot/dts/imx28-cfa10049.dts | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/arch/arm/boot/dts/imx28-cfa10049.dts b/arch/arm/boot/dts/imx28-cfa10049.dts index 063e620..fa91af5 100644 --- a/arch/arm/boot/dts/imx28-cfa10049.dts +++ b/arch/arm/boot/dts/imx28-cfa10049.dts @@ -33,7 +33,7 @@ 0x1163 /* MX28_PAD_LCD_D22__GPIO_1_22 */ 0x1173 /* MX28_PAD_LCD_D22__GPIO_1_23 */ 0x2153 /* MX28_PAD_SSP2_D5__GPIO_2_21 */ - 0x3173 /* MX28_PAD_LCD_RESET__GPIO_3_23 */ + 0x3053 /* MX28_PAD_AUART1_TX__GPIO_3_5 */ >; fsl,drive-strength = <0>; fsl,voltage = <1>; @@ -265,7 +265,7 @@ gpio-sck = <&gpio2 16 0>; gpio-mosi = <&gpio2 17 0>; gpio-miso = <&gpio2 18 0>; - cs-gpios = <&gpio3 23 0>; + cs-gpios = <&gpio3 5 0>; num-chipselects = <1>; #address-cells = <1>; #size-cells = <0>; -- 1.8.3