[PATCH v2 0/3] serial: mxs-auart: add RTS/CTS check for DMA support

[b32955@freescale.com (Huang Shijie)]

The original DMA support works only when RTS/CTS is enabled.
But after several patches, DMA support has lost this limit.
So a UART without the RTS/CTS lines may also enables the DMA support
for it, but it may does not work or works abnormally (since without the
RTS/CTS signals, the TX/RX may not works)		

This patch set remove the unnecessary macro MXS_AUART_DMA_CONFIG,
and adds an optional property "fsl,uart-has-rtscts" for the UART DT node
which indicates the UART has RTS and CTS lines.

This patch set also adds a macro MXS_AUART_RTSCTS, and uses it to check
RTS/CTS before we enable the DMA for the UART.

At last, enable the DMA support for auart0 in the imx28-evk boards.

v1 --> v2:
	[0] changed the comments.
	[1] fix the typos.

Huang Shijie (3):
  serial: mxs: remove the MXS_AUART_DMA_CONFIG
  serial: mxs: enable the DMA only when the RTS/CTS is valid
  ARM: dts: imx28-evk: add the RTS/CTS property for auart0

 .../bindings/tty/serial/fsl-mxs-auart.txt          |    4 ++++
 arch/arm/boot/dts/imx28-evk.dts                    |    1 +
 drivers/tty/serial/mxs-auart.c                     |    8 ++++----
 3 files changed, 9 insertions(+), 4 deletions(-)