From mboxrd@z Thu Jan 1 00:00:00 1970 From: sebastian.hesselbarth@gmail.com (Sebastian Hesselbarth) Date: Mon, 29 Jul 2013 14:31:49 +0200 Subject: [PATCH 0/5] ARM: dove: switch to DT MBus Message-ID: <1375101114-28858-1-git-send-email-sebastian.hesselbarth@gmail.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org This patch set converts DT based Dove boards to DT probed MBus to be introduced with v3.12. The first two patches prepare Dove DT nodes for MBus ID remapping by using preprocessor includes and adding the MBUS_ID macro. The third patch adds a MBus DT node to Dove SoC dtsi with required ranges for internal MBus and AXI registers, and PCIe mem and I/O apertures. The forth patch relocates the nodes for the internal devices to the new MBus node. Also, internal-regs ranges are updated to allow proper translation of MBus children's reg properties. Finally, legacy MBus init is replaced by DT based MBus init for DT based Dove. The patch set depends on the MBus device tree patches that should appear in v3.12. Currently, it is based on v3.11-rc2 with Dove DT cleanup patches and MBus patch set v8 applied. The patch set is _not_ sent to devicetree mainling list, because the MBus binding will be discussed there on the MBus patches itself. Sebastian Hesselbarth (5): ARM: dove: use preprocessor on device tree files ARM: dove: add MBUS_ID macro to Dove DT ARM: dove: add MBus DT node ARM: dove: relocate internal registers device nodes ARM: dove: switch to DT probed mbus address windows arch/arm/boot/dts/dove-cm-a510.dts | 2 +- arch/arm/boot/dts/dove-cubox.dts | 2 +- arch/arm/boot/dts/dove-d2plug.dts | 2 +- arch/arm/boot/dts/dove-dove-db.dts | 2 +- arch/arm/boot/dts/dove.dtsi | 958 ++++++++++++++++++------------------ arch/arm/mach-dove/board-dt.c | 10 +- 6 files changed, 491 insertions(+), 485 deletions(-) --- Cc: Russell King Cc: Jason Cooper Cc: Andrew Lunn Cc: Ezequiel Garcia Cc: linux-arm-kernel at lists.infradead.org Cc: linux-kernel at vger.kernel.org -- 1.7.10.4