From mboxrd@z Thu Jan 1 00:00:00 1970 From: rogerq@ti.com (Roger Quadros) Date: Thu, 15 Aug 2013 13:18:26 +0300 Subject: [PATCH v2 6/9] ARM: dts: omap4-panda: Use reset-gpios for hsusb1_reset In-Reply-To: <1376561909-4406-1-git-send-email-rogerq@ti.com> References: <1376561909-4406-1-git-send-email-rogerq@ti.com> Message-ID: <1376561909-4406-7-git-send-email-rogerq@ti.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org We no longer need to model the RESET line as a regulator since the USB phy-nop driver accepts "reset-gpios" property. Signed-off-by: Roger Quadros --- arch/arm/boot/dts/omap4-panda-common.dtsi | 18 +----------------- 1 files changed, 1 insertions(+), 17 deletions(-) diff --git a/arch/arm/boot/dts/omap4-panda-common.dtsi b/arch/arm/boot/dts/omap4-panda-common.dtsi index faa95b5..c60ebd0 100644 --- a/arch/arm/boot/dts/omap4-panda-common.dtsi +++ b/arch/arm/boot/dts/omap4-panda-common.dtsi @@ -60,22 +60,6 @@ "AFMR", "Line In"; }; - /* - * Temp hack: Need to be replaced with the proper gpio-controlled - * reset driver as soon it will be merged. - * http://thread.gmane.org/gmane.linux.drivers.devicetree/36830 - */ - /* HS USB Port 1 RESET */ - hsusb1_reset: hsusb1_reset_reg { - compatible = "regulator-fixed"; - regulator-name = "hsusb1_reset"; - regulator-min-microvolt = <3300000>; - regulator-max-microvolt = <3300000>; - gpio = <&gpio2 30 0>; /* gpio_62 */ - startup-delay-us = <70000>; - enable-active-high; - }; - /* HS USB Port 1 Power */ hsusb1_power: hsusb1_power_reg { compatible = "regulator-fixed"; @@ -97,7 +81,7 @@ /* HS USB Host PHY on PORT 1 */ hsusb1_phy: hsusb1_phy { compatible = "usb-nop-xceiv"; - reset-supply = <&hsusb1_reset>; + reset-gpios = <&gpio2 30 GPIO_ACTIVE_LOW>; /* gpio_62 */ vcc-supply = <&hsusb1_power>; /** * FIXME: -- 1.7.4.1