From mboxrd@z Thu Jan 1 00:00:00 1970 From: rogerq@ti.com (Roger Quadros) Date: Thu, 15 Aug 2013 13:18:27 +0300 Subject: [PATCH v2 7/9] ARM: dts: omap5-uevm: Use reset-gpios for hsusb2_reset In-Reply-To: <1376561909-4406-1-git-send-email-rogerq@ti.com> References: <1376561909-4406-1-git-send-email-rogerq@ti.com> Message-ID: <1376561909-4406-8-git-send-email-rogerq@ti.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org We no longer need to model the RESET line as a regulator since the USB phy-nop driver accepts "reset-gpios" property. Signed-off-by: Roger Quadros --- arch/arm/boot/dts/omap5-uevm.dts | 13 +------------ 1 files changed, 1 insertions(+), 12 deletions(-) diff --git a/arch/arm/boot/dts/omap5-uevm.dts b/arch/arm/boot/dts/omap5-uevm.dts index 65d7b60..c087762 100644 --- a/arch/arm/boot/dts/omap5-uevm.dts +++ b/arch/arm/boot/dts/omap5-uevm.dts @@ -27,21 +27,10 @@ regulator-max-microvolt = <3000000>; }; - /* HS USB Port 2 RESET */ - hsusb2_reset: hsusb2_reset_reg { - compatible = "regulator-fixed"; - regulator-name = "hsusb2_reset"; - regulator-min-microvolt = <3300000>; - regulator-max-microvolt = <3300000>; - gpio = <&gpio3 16 GPIO_ACTIVE_HIGH>; /* gpio3_80 HUB_NRESET */ - startup-delay-us = <70000>; - enable-active-high; - }; - /* HS USB Host PHY on PORT 2 */ hsusb2_phy: hsusb2_phy { compatible = "usb-nop-xceiv"; - reset-supply = <&hsusb2_reset>; + reset-gpios = <&gpio3 16 GPIO_ACTIVE_LOW>; /* gpio3_80 HUB_NRESET */ /** * FIXME * Put the right clock phandle here when available -- 1.7.4.1