From mboxrd@z Thu Jan 1 00:00:00 1970 From: linus.walleij@linaro.org (Linus Walleij) Date: Sun, 17 Nov 2013 12:03:57 +0100 Subject: [PATCH 08/21] ARM: ux500: create MCDE node to collect resources In-Reply-To: <1384686250-10542-1-git-send-email-linus.walleij@linaro.org> References: <1384686250-10542-1-git-send-email-linus.walleij@linaro.org> Message-ID: <1384686250-10542-9-git-send-email-linus.walleij@linaro.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org As we need to connect resources such as pin mappings and clocks when deleting board files, we create a MCDE node even though there is no driver for it. As it is only using standard bindings right now, this does not matter much. When a proper driver is written for the MCDE, it can augment this node with custom properties. Signed-off-by: Linus Walleij --- arch/arm/boot/dts/ste-dbx5x0.dtsi | 17 +++++++++++++++++ 1 file changed, 17 insertions(+) diff --git a/arch/arm/boot/dts/ste-dbx5x0.dtsi b/arch/arm/boot/dts/ste-dbx5x0.dtsi index 50ff5ab372d8..e0853ea02df2 100644 --- a/arch/arm/boot/dts/ste-dbx5x0.dtsi +++ b/arch/arm/boot/dts/ste-dbx5x0.dtsi @@ -1002,6 +1002,23 @@ status = "disabled"; }; + mcde at a0350000 { + compatible = "stericsson,mcde"; + reg = <0xa0350000 0x1000>, /* MCDE */ + <0xa0351000 0x1000>, /* DSI link 1 */ + <0xa0352000 0x1000>, /* DSI link 2 */ + <0xa0353000 0x1000>; /* DSI link 3 */ + interrupts = <0 48 IRQ_TYPE_LEVEL_HIGH>; + clocks = <&prcmu_clk PRCMU_MCDECLK>, /* Main MCDE clock */ + <&prcmu_clk PRCMU_LCDCLK>, /* LCD clock */ + <&prcmu_clk PRCMU_PLLDSI>, /* HDMI clock */ + <&prcmu_clk PRCMU_DSI0CLK>, /* DSI 0 */ + <&prcmu_clk PRCMU_DSI1CLK>, /* DSI 1 */ + <&prcmu_clk PRCMU_DSI0ESCCLK>, /* TVout clock 0 */ + <&prcmu_clk PRCMU_DSI1ESCCLK>, /* TVout clock 1 */ + <&prcmu_clk PRCMU_DSI2ESCCLK>; /* TVout clock 2 */ + }; + cryp at a03cb000 { compatible = "stericsson,ux500-cryp"; reg = <0xa03cb000 0x1000>; -- 1.8.3.1