From mboxrd@z Thu Jan 1 00:00:00 1970 From: maxime.ripard@free-electrons.com (Maxime Ripard) Date: Mon, 13 Jan 2014 11:34:53 +0100 Subject: [PATCH v2 5/5] ARM: sun6i: colombus: Enable the I2C controllers In-Reply-To: <1389609293-2824-1-git-send-email-maxime.ripard@free-electrons.com> References: <1389609293-2824-1-git-send-email-maxime.ripard@free-electrons.com> Message-ID: <1389609293-2824-6-git-send-email-maxime.ripard@free-electrons.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org The A31 Colombus board has 3 I2C controllers that should be usable. However, the first one is not working for some reason on the hardware I have been able to test it on, while it should really be the same controller. Enable the i2c1 and i2c2 busses, and mark i2c0 as in failure in the DT. Signed-off-by: Maxime Ripard --- arch/arm/boot/dts/sun6i-a31-colombus.dts | 18 ++++++++++++++++++ 1 file changed, 18 insertions(+) diff --git a/arch/arm/boot/dts/sun6i-a31-colombus.dts b/arch/arm/boot/dts/sun6i-a31-colombus.dts index e5adae3..3898a7b 100644 --- a/arch/arm/boot/dts/sun6i-a31-colombus.dts +++ b/arch/arm/boot/dts/sun6i-a31-colombus.dts @@ -28,5 +28,23 @@ pinctrl-0 = <&uart0_pins_a>; status = "okay"; }; + + i2c0: i2c at 01c2ac00 { + pinctrl-names = "default"; + pinctrl-0 = <&i2c0_pins_a>; + status = "fail"; + }; + + i2c1: i2c at 01c2b000 { + pinctrl-names = "default"; + pinctrl-0 = <&i2c1_pins_a>; + status = "okay"; + }; + + i2c2: i2c at 01c2b400 { + pinctrl-names = "default"; + pinctrl-0 = <&i2c2_pins_a>; + status = "okay"; + }; }; }; -- 1.8.4.2