[PATCH resend] ARM: dts: imx6qdl-wandboard: use GPIO_6 for FEC interrupt

[x-linux@infra-silbe.de (Sascha Silbe)]

Apply the same work-around for i.MX 6D/Q erratum 006687 as used for
Sabre Lite for the Wandboard Dual / Quad.

Like on the Sabre Lite, GPIO6 is used as a power down output for
camera expansion boards. However, these expansion boards do not work
with mainline yet anyway.

Tested on a Wandboard Quad. Before the patch:

root at arm:~# ping -q -f -c 10000 192.168.2.1
PING 192.168.2.1 (192.168.2.1) 56(84) bytes of data.

--- 192.168.2.1 ping statistics ---
10000 packets transmitted, 10000 received, 0% packet loss, time 97363ms
rtt min/avg/max/mdev = 0.290/9.586/10.198/1.432 ms, pipe 2, ipg/ewma 9.737/9.672 ms

After the patch:

root at arm:~# ping -q -f -c 10000 192.168.2.1
PING 192.168.2.1 (192.168.2.1) 56(84) bytes of data.

--- 192.168.2.1 ping statistics ---
10000 packets transmitted, 10000 received, 0% packet loss, time 4810ms
rtt min/avg/max/mdev = 0.246/0.355/0.863/0.044 ms, ipg/ewma 0.481/0.319 ms

Signed-off-by: Sascha Silbe <x-linux@infra-silbe.de>
---
 Resend after fixing up sendemail.envelopesender.

 arch/arm/boot/dts/imx6qdl-wandboard.dtsi | 3 +++
 1 file changed, 3 insertions(+)

diff --git a/arch/arm/boot/dts/imx6qdl-wandboard.dtsi b/arch/arm/boot/dts/imx6qdl-wandboard.dtsi
index d050888..4d82878 100644
--- a/arch/arm/boot/dts/imx6qdl-wandboard.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-wandboard.dtsi
@@ -123,6 +123,7 @@
 				MX6QDL_PAD_ENET_MDIO__ENET_MDIO		0x1b0b0
 				MX6QDL_PAD_ENET_MDC__ENET_MDC		0x1b0b0
 				MX6QDL_PAD_GPIO_16__ENET_REF_CLK	0x4001b0a8
+				MX6QDL_PAD_GPIO_6__ENET_IRQ		0x000b1
 			>;
 		};
 
@@ -201,6 +202,8 @@
 	pinctrl-0 = <&pinctrl_enet>;
 	phy-mode = "rgmii";
 	phy-reset-gpios = <&gpio3 29 0>;
+	interrupts-extended = <&gpio1 6 IRQ_TYPE_LEVEL_HIGH>,
+			      <&intc 0 119 IRQ_TYPE_LEVEL_HIGH>;
 	status = "okay";
 };
 
-- 
1.8.4.3