[PATCH 16/35] mtd: st_spi_fsm: Provide the sequence for enabling 32bit addressing mode

[lee.jones@linaro.org (Lee Jones)]

The FSM Serial Flash Controller is driven by issuing a standard set of
register writes we call a message sequence. This patch supplies a method
to prepare the message sequence responsible for setting 32bit addressing
mode on the Flash chip.

Acked-by Angus Clark <angus.clark@st.com>
Signed-off-by: Lee Jones <lee.jones@linaro.org>
---
 drivers/mtd/devices/st_spi_fsm.c | 22 ++++++++++++++++++++++
 1 file changed, 22 insertions(+)

diff --git a/drivers/mtd/devices/st_spi_fsm.c b/drivers/mtd/devices/st_spi_fsm.c
index 059188c..94b0cb4 100644
--- a/drivers/mtd/devices/st_spi_fsm.c
+++ b/drivers/mtd/devices/st_spi_fsm.c
@@ -411,6 +411,28 @@ static struct stfsm_seq stfsm_seq_erase_sector = {
 		    SEQ_CFG_STARTSEQ),
 };
 
+static int stfsm_n25q_en_32bit_addr_seq(struct stfsm_seq *seq)
+{
+	seq->seq_opc[0] = (SEQ_OPC_PADS_1 | SEQ_OPC_CYCLES(8) |
+			   SEQ_OPC_OPCODE(FLASH_CMD_EN4B_ADDR));
+	seq->seq_opc[1] = (SEQ_OPC_PADS_1 | SEQ_OPC_CYCLES(8) |
+			   SEQ_OPC_OPCODE(FLASH_CMD_WREN) |
+			   SEQ_OPC_CSDEASSERT);
+
+	seq->seq[0] = STFSM_INST_CMD2;
+	seq->seq[1] = STFSM_INST_CMD1;
+	seq->seq[2] = STFSM_INST_WAIT;
+	seq->seq[3] = STFSM_INST_STOP;
+
+	seq->seq_cfg = (SEQ_CFG_PADS_1 |
+			SEQ_CFG_ERASE |
+			SEQ_CFG_READNOTWRITE |
+			SEQ_CFG_CSDEASSERT |
+			SEQ_CFG_STARTSEQ);
+
+	return 0;
+}
+
 static inline int stfsm_is_idle(struct stfsm *fsm)
 {
 	return readl(fsm->base + SPI_FAST_SEQ_STA) & 0x10;
-- 
1.8.3.2