From mboxrd@z Thu Jan 1 00:00:00 1970 From: rogerq@ti.com (Roger Quadros) Date: Fri, 7 Mar 2014 15:09:08 +0200 Subject: [PATCH 5/8] phy: omap-usb2: Add clock names to Documentation binding In-Reply-To: <1394197751-28984-1-git-send-email-rogerq@ti.com> References: <1394197751-28984-1-git-send-email-rogerq@ti.com> Message-ID: <1394197751-28984-6-git-send-email-rogerq@ti.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Add "wkupclk" and "refclk" information to DT binding information. Signed-off-by: Roger Quadros --- Documentation/devicetree/bindings/phy/ti-phy.txt | 7 +++++++ 1 file changed, 7 insertions(+) diff --git a/Documentation/devicetree/bindings/phy/ti-phy.txt b/Documentation/devicetree/bindings/phy/ti-phy.txt index 4ab9cb1..49c381c 100644 --- a/Documentation/devicetree/bindings/phy/ti-phy.txt +++ b/Documentation/devicetree/bindings/phy/ti-phy.txt @@ -36,6 +36,11 @@ Required properties: - reg : Address and length of the register set for the device. - #phy-cells: determine the number of cells that should be given in the phandle while referencing this phy. + - clocks: a list of phandles and clock-specifier pairs, one for each entry in + clock-names. + - clock-names: should include: + * "wkupclk" - wakeup clock. + * "refclk" - reference clock (optional). Optional properties: - ctrl-module : phandle of the control module used by PHY driver to power on @@ -48,6 +53,8 @@ usb2phy at 4a0ad080 { reg = <0x4a0ad080 0x58>; ctrl-module = <&omap_control_usb>; #phy-cells = <0>; + clocks = <&usb_phy_cm_clk32k>, <&usb_otg_ss_refclk960m>; + clock-names = "wkupclk", "refclk"; }; TI PIPE3 PHY -- 1.8.3.2