From mboxrd@z Thu Jan 1 00:00:00 1970 From: hchaumette@adeneo-embedded.com (Hubert Chaumette) Date: Tue, 22 Apr 2014 18:09:12 +0200 Subject: [PATCH] ARM: i.MX6: Add OF configuration support for ksz9031 In-Reply-To: <20140416080322.GA11602@dragon> References: <1397466496-24750-1-git-send-email-hchaumette@adeneo-embedded.com> <20140416080322.GA11602@dragon> Message-ID: <1398182952.1593.20.camel@EMBLYSD005.adetelgroup.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Le mercredi 16 avril 2014 ? 16:03 +0800, Shawn Guo a ?crit : > On Mon, Apr 14, 2014 at 11:08:16AM +0200, Hubert Chaumette wrote: > > - Adds support for ksz9031 PAD skew configuration over devicetree > > - Removes hard-coded pad skew configuration for imx6q-sabrelite, now redundant > > with arch/arm/boot/dts/imx6qdl-sabrelite.dtsi > > > > Tested on congatec conga-QEVAL board with conga-QMX6 module. > > > > This patch is based on Anatolij Gustschin's patch from > > http://www.spinics.net/lists/arm-kernel/msg319771.html > > > > Signed-off-by: Hubert Chaumette > > --- > > arch/arm/mach-imx/mach-imx6q.c | 45 ---------- > > drivers/net/phy/micrel.c | 185 ++++++++++++++++++++++++++++++++++++++++- > > You should probably leave mach-imx6q.c unchanged, because dropping the > phy fix-up from there may break old DTBs. And the changes on micrel.c > should be submitted to net maintainer. > > Shawn I've re-sent it without the changes to mach-imx6q.c. Thanks for your review. Regards, Hubert