From mboxrd@z Thu Jan 1 00:00:00 1970 From: lee.jones@linaro.org (Lee Jones) Date: Wed, 21 May 2014 09:45:23 +0100 Subject: [PATCH v2 2/3] ARM: sti: stih416: Enable board LED support for B2020 RevE In-Reply-To: <1400661924-10745-1-git-send-email-lee.jones@linaro.org> References: <1400661924-10745-1-git-send-email-lee.jones@linaro.org> Message-ID: <1400661924-10745-2-git-send-email-lee.jones@linaro.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org There are two LEDs available on the B2020 RevE board, one red, one green. In this patch we enable the red one for "heartbeat" and turn the green one off. Signed-off-by: Lee Jones --- arch/arm/boot/dts/stih416-b2020-revE.dts | 14 ++++++++++++++ 1 file changed, 14 insertions(+) diff --git a/arch/arm/boot/dts/stih416-b2020-revE.dts b/arch/arm/boot/dts/stih416-b2020-revE.dts index da3c1c4..ba0fa2c 100644 --- a/arch/arm/boot/dts/stih416-b2020-revE.dts +++ b/arch/arm/boot/dts/stih416-b2020-revE.dts @@ -14,6 +14,20 @@ compatible = "st,stih416-b2020", "st,stih416"; soc { + leds { + compatible = "gpio-leds"; + red { + #gpio-cells = <1>; + label = "Front Panel LED"; + gpios = <&PIO4 1>; + linux,default-trigger = "heartbeat"; + }; + green { + gpios = <&PIO1 3>; + default-state = "off"; + }; + }; + ethernet1: dwmac at fef08000 { snps,reset-gpio = <&PIO0 7>; }; -- 1.8.3.2