From mboxrd@z Thu Jan 1 00:00:00 1970 From: daniel.thompson@linaro.org (Daniel Thompson) Date: Fri, 23 May 2014 16:10:18 +0100 Subject: [RESEND PATCH v5 4/5] arm: Seperate DEBUG_UART_PHYS from DEBUG_LL on EP93XX In-Reply-To: <1400857819-7975-1-git-send-email-daniel.thompson@linaro.org> References: <1398355246-29571-1-git-send-email-daniel.thompson@linaro.org> <1400857819-7975-1-git-send-email-daniel.thompson@linaro.org> Message-ID: <1400857819-7975-5-git-send-email-daniel.thompson@linaro.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On EP93XX uncompress.h uses CONFIG_DEBUG_UART_PHYS instead of a hard coded serial port. This means the build breaks when DEBUG_LL (and DEBUG_LL_UART_PL01X) is not enabled. This is fixed by adding a new dependancy. Signed-off-by: Daniel Thompson --- arch/arm/Kconfig.debug | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-) diff --git a/arch/arm/Kconfig.debug b/arch/arm/Kconfig.debug index 4c8d7db..468cb3b 100644 --- a/arch/arm/Kconfig.debug +++ b/arch/arm/Kconfig.debug @@ -1069,7 +1069,8 @@ config DEBUG_UART_PHYS default 0xfffff700 if ARCH_IOP33X depends on DEBUG_LL_UART_8250 || DEBUG_LL_UART_PL01X || \ DEBUG_LL_UART_EFM32 || \ - DEBUG_UART_8250 || DEBUG_UART_PL01X + DEBUG_UART_8250 || DEBUG_UART_PL01X || \ + ARCH_EP93XX config DEBUG_UART_VIRT hex "Virtual base address of debug UART" -- 1.9.0