[PATCH 3/9] ARM: tegra: Add SATA and SATA power to Jetson TK1 device tree

[mperttunen@nvidia.com (Mikko Perttunen)]

This enables the integrated SATA controller on the Tegra124 system-on-chip
on the Jetson TK1 board and adds regulators for the onboard Molex connector
commonly used to power SATA devices. The regulators are marked always-on
since they can be used for other purposes than powering SATA devices.

Signed-off-by: Mikko Perttunen <mperttunen@nvidia.com>
Cc: devicetree at vger.kernel.org
---
 arch/arm/boot/dts/tegra124-jetson-tk1.dts | 36 +++++++++++++++++++++++++++++++
 1 file changed, 36 insertions(+)

diff --git a/arch/arm/boot/dts/tegra124-jetson-tk1.dts b/arch/arm/boot/dts/tegra124-jetson-tk1.dts
index 38d3087..33a062c 100644
--- a/arch/arm/boot/dts/tegra124-jetson-tk1.dts
+++ b/arch/arm/boot/dts/tegra124-jetson-tk1.dts
@@ -1686,6 +1686,17 @@
 		vbus-supply = <&vdd_usb3_vbus>;
 	};
 
+	/* Serial ATA */
+	sata at 0,70020000 {
+		status = "okay";
+
+		hvdd-supply = <&vdd_3v3_lp0>;
+		vddio-supply = <&vdd_1v05_run>;
+		avdd-supply = <&vdd_1v05_run>;
+
+		target-supply = <&vdd_5v0_sata>;
+	};
+
 	clocks {
 		compatible = "simple-bus";
 		#address-cells = <1>;
@@ -1827,6 +1838,31 @@
 			enable-active-high;
 			vin-supply = <&vdd_5v0_sys>;
 		};
+
+		/* Molex power connector */
+		vdd_5v0_sata: regulator at 13 {
+			compatible = "regulator-fixed";
+			reg = <13>;
+			regulator-name = "+5V_SATA";
+			regulator-min-microvolt = <5000000>;
+			regulator-max-microvolt = <5000000>;
+			gpio = <&gpio TEGRA_GPIO(EE, 2) GPIO_ACTIVE_HIGH>;
+			enable-active-high;
+			vin-supply = <&vdd_5v0_sys>;
+			regulator-always-on;
+		};
+
+		vdd_12v0_sata: regulator at 14 {
+			compatible = "regulator-fixed";
+			reg = <14>;
+			regulator-name = "+12V_SATA";
+			regulator-min-microvolt = <12000000>;
+			regulator-max-microvolt = <12000000>;
+			gpio = <&gpio TEGRA_GPIO(EE, 2) GPIO_ACTIVE_HIGH>;
+			enable-active-high;
+			vin-supply = <&vdd_mux>;
+			regulator-always-on;
+		};
 	};
 
 	sound {
-- 
1.8.1.5