From mboxrd@z Thu Jan 1 00:00:00 1970 From: lee.jones@linaro.org (Lee Jones) Date: Wed, 18 Jun 2014 15:52:46 +0100 Subject: [PATCH 1/7] ARM: stih407: Add DT nodes for for PWM Message-ID: <1403103172-19856-1-git-send-email-lee.jones@linaro.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Supply top level nodes for the STiH407 based development boards. The Pinctrl configuration has already been applied, so the only missing piece of the DT puzzle is for a board's DTB to enable the nodes. Signed-off-by: Lee Jones --- arch/arm/boot/dts/stih407.dtsi | 27 +++++++++++++++++++++++++++ 1 file changed, 27 insertions(+) diff --git a/arch/arm/boot/dts/stih407.dtsi b/arch/arm/boot/dts/stih407.dtsi index 4f9024f..6b43ba2 100644 --- a/arch/arm/boot/dts/stih407.dtsi +++ b/arch/arm/boot/dts/stih407.dtsi @@ -259,5 +259,32 @@ status = "disabled"; }; + + /* COMMS PWM Module */ + pwm0: pwm at 9810000 { + compatible = "st,sti-pwm"; + status = "disabled"; + #pwm-cells = <2>; + reg = <0x9810000 0x68>; + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_pwm0_chan0_default>; + clock-names = "pwm"; + clocks = <&clk_sysin>; + }; + + /* SBC PWM Module */ + pwm1: pwm at 9510000 { + compatible = "st,sti-pwm"; + status = "disabled"; + #pwm-cells = <2>; + reg = <0x9510000 0x68>; + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_pwm1_chan0_default + &pinctrl_pwm1_chan1_default + &pinctrl_pwm1_chan2_default + &pinctrl_pwm1_chan3_default>; + clock-names = "pwm"; + clocks = <&clk_sysin>; + }; }; }; -- 1.8.3.2