[PATCH 4/6] ARM: tegra: Add soctherm and thermal zones to Tegra124 device tree

[mperttunen@nvidia.com (Mikko Perttunen)]

This adds the soctherm thermal sensing and management unit to the
Tegra124 device tree along with the four thermal zones it exports.

Signed-off-by: Mikko Perttunen <mperttunen@nvidia.com>
---
 arch/arm/boot/dts/tegra124.dtsi | 48 +++++++++++++++++++++++++++++++++++++++++
 1 file changed, 48 insertions(+)

diff --git a/arch/arm/boot/dts/tegra124.dtsi b/arch/arm/boot/dts/tegra124.dtsi
index d675186..853627f 100644
--- a/arch/arm/boot/dts/tegra124.dtsi
+++ b/arch/arm/boot/dts/tegra124.dtsi
@@ -2,6 +2,7 @@
 #include <dt-bindings/gpio/tegra-gpio.h>
 #include <dt-bindings/pinctrl/pinctrl-tegra.h>
 #include <dt-bindings/interrupt-controller/arm-gic.h>
+#include <dt-bindings/thermal/tegra124-soctherm.h>
 
 #include "skeleton.dtsi"
 
@@ -724,6 +725,53 @@
 		status = "disabled";
 	};
 
+	thermal-zones {
+		cpu {
+			polling-delay-passive = <0>;
+			polling-delay = <0>;
+
+			thermal-sensors =
+				<&soctherm TEGRA124_SOCTHERM_SENSOR_CPU>;
+		};
+
+		mem {
+			polling-delay-passive = <0>;
+			polling-delay = <0>;
+
+			thermal-sensors =
+				<&soctherm TEGRA124_SOCTHERM_SENSOR_MEM>;
+		};
+
+		gpu {
+			polling-delay-passive = <0>;
+			polling-delay = <0>;
+
+			thermal-sensors =
+				<&soctherm TEGRA124_SOCTHERM_SENSOR_GPU>;
+		};
+
+		pllx {
+			polling-delay-passive = <0>;
+			polling-delay = <0>;
+
+			thermal-sensors =
+				<&soctherm TEGRA124_SOCTHERM_SENSOR_PLLX>;
+		};
+	};
+
+	soctherm: soctherm at 0,700e2000 {
+		compatible = "nvidia,tegra124-soctherm";
+		reg = <0x0 0x700e2000 0x0 0x1000>;
+		interrupts = <GIC_SPI 48 IRQ_TYPE_LEVEL_HIGH>;
+		clocks = <&tegra_car TEGRA124_CLK_TSENSOR>,
+			<&tegra_car TEGRA124_CLK_SOC_THERM>;
+		clock-names = "tsensor", "soctherm";
+		resets = <&tegra_car 78>;
+		reset-names = "soctherm";
+
+		#thermal-sensor-cells = <1>;
+	};
+
 	cpus {
 		#address-cells = <1>;
 		#size-cells = <0>;
-- 
1.8.1.5