[PATCH 05/12] ARM: dts: Do not set pulls for I2C lines

[tony@atomide.com (Tony Lindgren)]

There are external pulls on these lines and enabling the
internal pulls can cause issue. This is because the internal
pulls are parallel with the external pulls. So let's clear
the internal I2C pulls.

Signed-off-by: Tony Lindgren <tony@atomide.com>
---
 arch/arm/boot/dts/omap3-n900.dts | 12 ++++++------
 1 file changed, 6 insertions(+), 6 deletions(-)

diff --git a/arch/arm/boot/dts/omap3-n900.dts b/arch/arm/boot/dts/omap3-n900.dts
index 1fe45d1..f0d8236 100644
--- a/arch/arm/boot/dts/omap3-n900.dts
+++ b/arch/arm/boot/dts/omap3-n900.dts
@@ -136,22 +136,22 @@
 
 	i2c1_pins: pinmux_i2c1_pins {
 		pinctrl-single,pins = <
-			0x18a (PIN_INPUT_PULLUP | MUX_MODE0)	/* i2c1_scl */
-			0x18c (PIN_INPUT_PULLUP | MUX_MODE0)	/* i2c1_sda */
+			0x18a (PIN_INPUT | MUX_MODE0)		/* i2c1_scl */
+			0x18c (PIN_INPUT | MUX_MODE0)		/* i2c1_sda */
 		>;
 	};
 
 	i2c2_pins: pinmux_i2c2_pins {
 		pinctrl-single,pins = <
-			0x18e (PIN_INPUT_PULLUP | MUX_MODE0)	/* i2c2_scl */
-			0x190 (PIN_INPUT_PULLUP | MUX_MODE0)	/* i2c2_sda */
+			0x18e (PIN_INPUT | MUX_MODE0)		/* i2c2_scl */
+			0x190 (PIN_INPUT | MUX_MODE0)		/* i2c2_sda */
 		>;
 	};
 
 	i2c3_pins: pinmux_i2c3_pins {
 		pinctrl-single,pins = <
-			0x192 (PIN_INPUT_PULLUP | MUX_MODE0)	/* i2c3_scl */
-			0x194 (PIN_INPUT_PULLUP | MUX_MODE0)	/* i2c3_sda */
+			0x192 (PIN_INPUT | MUX_MODE0)		/* i2c3_scl */
+			0x194 (PIN_INPUT | MUX_MODE0)		/* i2c3_sda */
 		>;
 	};
 
-- 
2.1.0