[PATCH 1/2 v2] SPI: spi-pxa2xx: Add helpers for regiseters' accessing

[andriy.shevchenko@linux.intel.com (Andy Shevchenko)]

On Mon, 2014-09-29 at 07:22 -0700, Weike Chen wrote:


I'm okay with the current version, though I have few minor comments
below.

> Introduce helper functions to access the 'SSCR0' and 'SSCR1'.
> 

Like you said in the summary there are many accessors to many registers,
not only cr1/cr0. Perhaps, you may extend your commit message.

In any case
Reviewed-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>


More comments below.

> Signed-off-by: Weike Chen <alvin.chen@intel.com>
> ---
>  drivers/spi/spi-pxa2xx.c |  108 ++++++++++++++++++++++++++++++++++++----------
>  1 file changed, 85 insertions(+), 23 deletions(-)
> 
> diff --git a/drivers/spi/spi-pxa2xx.c b/drivers/spi/spi-pxa2xx.c
> index 256c0ab..e7ff9c5 100644
> --- a/drivers/spi/spi-pxa2xx.c
> +++ b/drivers/spi/spi-pxa2xx.c
> @@ -80,6 +80,73 @@ static bool is_lpss_ssp(const struct driver_data *drv_data)
>  	return drv_data->ssp_type == LPSS_SSP;
>  }
>  
> +static u32 pxa2xx_spi_get_ssrc1_change_mask(const struct driver_data *drv_data)
> +{
> +	switch (drv_data->ssp_type) {
> +	default:
> +		return SSCR1_CHANGE_MASK;
> +	}
> +}
> +
> +static u32
> +pxa2xx_spi_get_rx_default_thre(const struct driver_data *drv_data)
> +{
> +	switch (drv_data->ssp_type) {
> +	default:
> +		return RX_THRESH_DFLT;
> +	}
> +}
> +
> +static bool pxa2xx_spi_txfifo_full(const struct driver_data *drv_data)
> +{
> +	void __iomem *reg = drv_data->ioaddr;
> +	u32 mask;
> +
> +	switch (drv_data->ssp_type) {
> +	default:
> +		mask = SSSR_TFL_MASK;
> +		break;
> +	}
> +
> +	return (read_SSSR(reg) & mask) == mask;
> +}
> +
> +static void pxa2xx_spi_clear_rx_thre(const struct driver_data *drv_data,
> +				     u32 *sccr1_reg)
> +{
> +	u32 mask;
> +
> +	switch (drv_data->ssp_type) {
> +	default:
> +		mask = SSCR1_RFT;
> +		break;
> +	}
> +	*sccr1_reg &= ~mask;
> +}
> +
> +static void pxa2xx_spi_set_rx_thre(const struct driver_data *drv_data,
> +				   u32 *sccr1_reg, u32 threshold)
> +{
> +	switch (drv_data->ssp_type) {
> +	default:
> +		*sccr1_reg |= SSCR1_RxTresh(threshold);
> +		break;
> +	}
> +}
> +
> +static u32 pxa2xx_configure_sscr0(const struct driver_data *drv_data,
> +				  u32 clk_div, u8 bits)
> +{
> +	switch (drv_data->ssp_type) {
> +	default:
> +		return clk_div
> +			| SSCR0_Motorola
> +			| SSCR0_DataSize(bits > 16 ? bits - 16 : bits)
> +			| SSCR0_SSE
> +			| (bits > 16 ? SSCR0_EDSS : 0);
> +	}
> +}
> +
>  /*
>   * Read and write LPSS SSP private registers. Caller must first check that
>   * is_lpss_ssp() returns true before these can be called.
> @@ -234,7 +301,7 @@ static int null_writer(struct driver_data *drv_data)
>  	void __iomem *reg = drv_data->ioaddr;
>  	u8 n_bytes = drv_data->n_bytes;
>  
> -	if (((read_SSSR(reg) & SSSR_TFL_MASK) == SSSR_TFL_MASK)
> +	if (pxa2xx_spi_txfifo_full(drv_data)
>  		|| (drv_data->tx == drv_data->tx_end))

Just wondering if those two could fit one line.

>  		return 0;
>  
> @@ -262,7 +329,7 @@ static int u8_writer(struct driver_data *drv_data)
>  {
>  	void __iomem *reg = drv_data->ioaddr;
>  
> -	if (((read_SSSR(reg) & SSSR_TFL_MASK) == SSSR_TFL_MASK)
> +	if (pxa2xx_spi_txfifo_full(drv_data)
>  		|| (drv_data->tx == drv_data->tx_end))

Ditto.

>  		return 0;
>  
> @@ -289,7 +356,7 @@ static int u16_writer(struct driver_data *drv_data)
>  {
>  	void __iomem *reg = drv_data->ioaddr;
>  
> -	if (((read_SSSR(reg) & SSSR_TFL_MASK) == SSSR_TFL_MASK)
> +	if (pxa2xx_spi_txfifo_full(drv_data)
>  		|| (drv_data->tx == drv_data->tx_end))

Ditto.

>  		return 0;
>  
> @@ -316,7 +383,7 @@ static int u32_writer(struct driver_data *drv_data)
>  {
>  	void __iomem *reg = drv_data->ioaddr;
>  
> -	if (((read_SSSR(reg) & SSSR_TFL_MASK) == SSSR_TFL_MASK)
> +	if (pxa2xx_spi_txfifo_full(drv_data)
>  		|| (drv_data->tx == drv_data->tx_end))

Ditto.

>  		return 0;
>  
> @@ -508,8 +575,9 @@ static irqreturn_t interrupt_transfer(struct driver_data *drv_data)
>  		 * remaining RX bytes.
>  		 */
>  		if (pxa25x_ssp_comp(drv_data)) {
> +			u32 rx_thre;
>  
> -			sccr1_reg &= ~SSCR1_RFT;
> +			pxa2xx_spi_clear_rx_thre(drv_data, &sccr1_reg);
>  
>  			bytes_left = drv_data->rx_end - drv_data->rx;
>  			switch (drv_data->n_bytes) {
> @@ -519,10 +587,12 @@ static irqreturn_t interrupt_transfer(struct driver_data *drv_data)
>  				bytes_left >>= 1;
>  			}
>  
> -			if (bytes_left > RX_THRESH_DFLT)
> -				bytes_left = RX_THRESH_DFLT;
> +			rx_thre = pxa2xx_spi_get_rx_default_thre(drv_data);
> +			if (rx_thre > bytes_left)
> +				rx_thre = bytes_left;
>  
> -			sccr1_reg |= SSCR1_RxTresh(bytes_left);
> +			pxa2xx_spi_set_rx_thre(drv_data, &sccr1_reg,
> +					       rx_thre);
>  		}
>  		write_SSCR1(sccr1_reg, reg);
>  	}
> @@ -613,6 +683,7 @@ static void pump_transfers(unsigned long data)
>  	u32 cr1;
>  	u32 dma_thresh = drv_data->cur_chip->dma_threshold;
>  	u32 dma_burst = drv_data->cur_chip->dma_burst_size;
> +	u32 change_mask = pxa2xx_spi_get_ssrc1_change_mask(drv_data);
>  
>  	/* Get current state information */
>  	message = drv_data->cur_msg;
> @@ -731,11 +802,7 @@ static void pump_transfers(unsigned long data)
>  						     "pump_transfers: DMA burst size reduced to match bits_per_word\n");
>  		}
>  
> -		cr0 = clk_div
> -			| SSCR0_Motorola
> -			| SSCR0_DataSize(bits > 16 ? bits - 16 : bits)
> -			| SSCR0_SSE
> -			| (bits > 16 ? SSCR0_EDSS : 0);
> +		cr0 = pxa2xx_configure_sscr0(drv_data, clk_div, bits);
>  	}
>  
>  	message->state = RUNNING_STATE;
> @@ -772,16 +839,15 @@ static void pump_transfers(unsigned long data)
>  	}
>  
>  	/* see if we need to reload the config registers */
> -	if ((read_SSCR0(reg) != cr0)
> -		|| (read_SSCR1(reg) & SSCR1_CHANGE_MASK) !=
> -			(cr1 & SSCR1_CHANGE_MASK)) {
> +	if ((read_SSCR0(reg) != cr0) ||
> +	    (read_SSCR1(reg) & change_mask) != (cr1 & change_mask)) {
>  
>  		/* stop the SSP, and update the other bits */
>  		write_SSCR0(cr0 & ~SSCR0_SSE, reg);
>  		if (!pxa25x_ssp_comp(drv_data))
>  			write_SSTO(chip->timeout, reg);
>  		/* first set CR1 without interrupt and service enables */
> -		write_SSCR1(cr1 & SSCR1_CHANGE_MASK, reg);
> +		write_SSCR1(cr1 & change_mask, reg);
>  		/* restart the SSP */
>  		write_SSCR0(cr0, reg);
>  
> @@ -959,12 +1025,8 @@ static int setup(struct spi_device *spi)
>  	clk_div = ssp_get_clk_div(drv_data, spi->max_speed_hz);
>  	chip->speed_hz = spi->max_speed_hz;
>  
> -	chip->cr0 = clk_div
> -			| SSCR0_Motorola
> -			| SSCR0_DataSize(spi->bits_per_word > 16 ?
> -				spi->bits_per_word - 16 : spi->bits_per_word)
> -			| SSCR0_SSE
> -			| (spi->bits_per_word > 16 ? SSCR0_EDSS : 0);
> +	chip->cr0 = pxa2xx_configure_sscr0(drv_data, clk_div,
> +					   spi->bits_per_word);
>  	chip->cr1 &= ~(SSCR1_SPO | SSCR1_SPH);
>  	chip->cr1 |= (((spi->mode & SPI_CPHA) != 0) ? SSCR1_SPH : 0)
>  			| (((spi->mode & SPI_CPOL) != 0) ? SSCR1_SPO : 0);


-- 
Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Intel Finland Oy