From mboxrd@z Thu Jan 1 00:00:00 1970 From: wenyou.yang@atmel.com (Wenyou Yang) Date: Fri, 24 Oct 2014 14:50:17 +0800 Subject: [PATCH v3 3/3] i2c/at91: adopt pinctrl support In-Reply-To: <1414133417-11530-1-git-send-email-wenyou.yang@atmel.com> References: <1414133417-11530-1-git-send-email-wenyou.yang@atmel.com> Message-ID: <1414133417-11530-4-git-send-email-wenyou.yang@atmel.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Amend the i2c at91 pin controller to optionally take a pin control handle and set the state of the pins to: - "default" on boot, resume and before performing an transfer - "sleep" on suspend() This should make it possible to optimize energy usage for the pins both for the suspend/resume cycle Signed-off-by: Wenyou Yang --- drivers/i2c/busses/i2c-at91.c | 7 +++++++ 1 file changed, 7 insertions(+) diff --git a/drivers/i2c/busses/i2c-at91.c b/drivers/i2c/busses/i2c-at91.c index 6a84a2a..290caf1 100644 --- a/drivers/i2c/busses/i2c-at91.c +++ b/drivers/i2c/busses/i2c-at91.c @@ -32,6 +32,7 @@ #include #include #include +#include #define DEFAULT_TWI_CLK_HZ 100000 /* max 400 Kbits/s */ #define AT91_I2C_TIMEOUT msecs_to_jiffies(100) /* transfer timeout */ @@ -747,6 +748,8 @@ static int at91_twi_probe(struct platform_device *pdev) u32 phy_addr; u32 bus_clk_rate; + pinctrl_pm_select_default_state(&pdev->dev); + dev = devm_kzalloc(&pdev->dev, sizeof(*dev), GFP_KERNEL); if (!dev) return -ENOMEM; @@ -851,6 +854,8 @@ static int at91_twi_runtime_suspend(struct device *dev) clk_disable_unprepare(twi_dev->clk); + pinctrl_pm_select_sleep_state(dev); + return 0; } @@ -858,6 +863,8 @@ static int at91_twi_runtime_resume(struct device *dev) { struct at91_twi_dev *twi_dev = dev_get_drvdata(dev); + pinctrl_pm_select_default_state(dev); + return clk_prepare_enable(twi_dev->clk); } -- 1.7.9.5