From: peter.griffin@linaro.org (Peter Griffin)
To: linux-arm-kernel@lists.infradead.org
Subject: [PATCH 00/13] Add stih410 SoC and USB2/1.1 support
Date: Fri, 7 Nov 2014 11:57:42 +0000 [thread overview]
Message-ID: <1415361475-6218-1-git-send-email-peter.griffin@linaro.org> (raw)
Hi,
This series adds the required device tree nodes to enable the usb2/1.1 phy
and usb2/1.1 controllers on the stih416-b2120 board.
It additionally re-works and adds support for the new stih410 SoC which is
very similar to the stih407 SoC, by abstracting out the common parts
into common dt files. It also then adds the dt nodes to enable usb2/1.1
for the stih410 platform as well.
As well as adding dt nodes it also enables the relevant drivers in the
mult7_v7_defconfig.
Finally we update the default bootargs for stih407-b2120 and stih410-b2120
to boot with the clk_ignore_unused kernel parameter so as not to hang
the SoC when the (as yet) unreferenced interconnect clocks get disabled
by CCF (this is a tempoary solution).
This series has been tested on stih416-b2020 and stih410-b2120 SoC/boards.
regards,
Peter.
Peter Griffin (13):
ARM: STi: DT: STiH416: Add pinctl setup for usb controllers.
ARM: STi: DT: STiH416: Add DT node for the stih415/6 usb2 phy
ARM: STi: DT: STiH416: Add DT nodes for the ehci and ohci usb
controllers.
ARM: multi_v7_defconfig: Enable st ohci and ehci HCD drivers.
ARM: multi_v7_defconfig: Enable stih415/6 usb2 phy driver.
ARM: multi_v7_defconfig: Enable stih407 usb picophy
ARM: STi: DT: STiH407: Add usb2 picophy dt nodes
ARM: STi: DT: STiH410: Add defines for STiH410 DT clocks
ARM: STi: DT: STiH410: Add pinctl config for usb controllers.
ARM: STi: DT: STih410: Add dt nodes for the ehci / ohci usb
controllers.
ARM: STi: DT: STih407: Abstract common dt nodes into shared files.
ARM: STi: DT: STiH410: Add STiH410 SoC clock support.
ARM: STi: DT: STih407: Add clk_ignore_unused to kernel bootargs
arch/arm/boot/dts/Makefile | 1 +
arch/arm/boot/dts/stih407-b2120.dts | 67 +-----
arch/arm/boot/dts/stih407-family.dtsi | 384 +++++++++++++++++++++++++++++++
arch/arm/boot/dts/stih407-pinctrl.dtsi | 18 ++
arch/arm/boot/dts/stih407.dtsi | 279 ----------------------
arch/arm/boot/dts/stih410-b2120.dts | 42 ++++
arch/arm/boot/dts/stih410-clock.dtsi | 338 +++++++++++++++++++++++++++
arch/arm/boot/dts/stih416-b2020.dts | 4 +
arch/arm/boot/dts/stih416-b2020e.dts | 4 +
arch/arm/boot/dts/stih416-pinctrl.dtsi | 34 +++
arch/arm/boot/dts/stih416.dtsi | 153 ++++++++++++
arch/arm/boot/dts/stih41x-b2020.dtsi | 12 +
arch/arm/boot/dts/stihxxx-b2120.dtsi | 73 ++++++
arch/arm/configs/multi_v7_defconfig | 4 +
include/dt-bindings/clock/stih410-clks.h | 24 ++
15 files changed, 1094 insertions(+), 343 deletions(-)
create mode 100644 arch/arm/boot/dts/stih407-family.dtsi
delete mode 100644 arch/arm/boot/dts/stih407.dtsi
create mode 100644 arch/arm/boot/dts/stih410-b2120.dts
create mode 100644 arch/arm/boot/dts/stih410-clock.dtsi
create mode 100644 arch/arm/boot/dts/stihxxx-b2120.dtsi
create mode 100644 include/dt-bindings/clock/stih410-clks.h
--
1.9.1
next reply other threads:[~2014-11-07 11:57 UTC|newest]
Thread overview: 33+ messages / expand[flat|nested] mbox.gz Atom feed top
2014-11-07 11:57 Peter Griffin [this message]
2014-11-07 11:57 ` [PATCH 01/13] ARM: STi: DT: STiH416: Add pinctl setup for usb controllers Peter Griffin
2014-11-10 10:50 ` Lee Jones
2014-11-07 11:57 ` [PATCH 02/13] ARM: STi: DT: STiH416: Add DT node for the stih415/6 usb2 phy Peter Griffin
2014-11-10 10:49 ` Lee Jones
2014-11-12 13:55 ` Peter Griffin
2014-11-07 11:57 ` [PATCH 03/13] ARM: STi: DT: STiH416: Add DT nodes for the ehci and ohci usb controllers Peter Griffin
2014-11-07 12:08 ` Arnd Bergmann
2014-11-12 13:44 ` Peter Griffin
2014-11-07 11:57 ` [PATCH 04/13] ARM: multi_v7_defconfig: Enable st ohci and ehci HCD drivers Peter Griffin
2014-11-10 10:48 ` Lee Jones
2014-11-07 11:57 ` [PATCH 05/13] ARM: multi_v7_defconfig: Enable stih415/6 usb2 phy driver Peter Griffin
2014-11-10 10:47 ` Lee Jones
2014-11-07 11:57 ` [PATCH 06/13] ARM: multi_v7_defconfig: Enable stih407 usb picophy Peter Griffin
2014-11-10 10:28 ` Lee Jones
2014-11-07 11:57 ` [PATCH 07/13] ARM: STi: DT: STiH407: Add usb2 picophy dt nodes Peter Griffin
2014-11-10 10:11 ` Lee Jones
2014-11-13 10:22 ` Peter Griffin
2014-11-07 11:57 ` [PATCH 08/13] ARM: STi: DT: STiH410: Add defines for STiH410 DT clocks Peter Griffin
2014-11-10 10:08 ` Lee Jones
2014-11-07 11:57 ` [PATCH 09/13] ARM: STi: DT: STiH410: Add pinctl config for usb controllers Peter Griffin
2014-11-10 10:06 ` Lee Jones
2014-11-07 11:57 ` [PATCH 10/13] ARM: STi: DT: STih410: Add dt nodes for the ehci / ohci " Peter Griffin
2014-11-10 9:26 ` Maxime Coquelin
2014-11-10 10:06 ` Lee Jones
2014-11-07 11:57 ` [PATCH 11/13] ARM: STi: DT: STih407: Abstract common dt nodes into shared files Peter Griffin
2014-11-07 12:10 ` Arnd Bergmann
2014-11-07 11:57 ` [PATCH 12/13] ARM: STi: DT: STiH410: Add STiH410 SoC clock support Peter Griffin
2014-11-07 12:13 ` Arnd Bergmann
2014-11-12 13:48 ` Peter Griffin
2014-11-10 9:20 ` Maxime Coquelin
2014-11-07 11:57 ` [PATCH 13/13] ARM: STi: DT: STih407: Add clk_ignore_unused to kernel bootargs Peter Griffin
2014-11-10 10:04 ` Lee Jones
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1415361475-6218-1-git-send-email-peter.griffin@linaro.org \
--to=peter.griffin@linaro.org \
--cc=linux-arm-kernel@lists.infradead.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).