[PATCH 3/7] regulator: MT6397: Add support for MT6397 regulator

[flora.fu@mediatek.com (Flora Fu)]

Hi, Mark, 

On Mon, 2014-11-17 at 23:40 +0000, Mark Brown wrote:
> On Mon, Nov 17, 2014 at 03:40:23PM +0800, Flora Fu wrote:

> > +static int mt6397_buck_set_voltage_sel(struct regulator_dev *rdev, unsigned sel)
> > +{
> 
> 
> > +	vosel = info->buck_conf.vosel_reg;
> > +	voselon = info->buck_conf.voselon_reg;
> > +	vosel_mask = info->buck_conf.vosel_mask;
> 
> Please use the standard way of specifying data even if you can't use the
> standard function.
> 

Could you specify the standard way of specification data? Thanks. 

> > +
> > +	ret = regmap_update_bits(rdev->regmap, vosel, vosel_mask, sel);
> > +	if (ret != 0) {
> > +		dev_err(&rdev->dev, "Failed to update vosel: %d\n", ret);
> > +		return ret;
> > +	}
> > +
> > +	ret = regmap_update_bits(rdev->regmap, voselon, vosel_mask, sel);
> > +	if (ret != 0) {
> > +		dev_err(&rdev->dev, "Failed to update vosel_on: %d\n", ret);
> > +		return ret;
> > +	}
> > +	return 0;
> 
> You should add comments here explaining what's going on - it's very
> strange to have to write the same value to two different registers and
> the names of the registers look suspiciously like this is something to do
> with a suspend mode...
> 

Yes, its is for suspend mode control usage.
For registers "vosel", "voselon", they is called register mode or
hardware control mode voltage settings. Register mode is a default mode
on the buck control. For quickly normal/sleep mode switch, hardware
control can be enabled by controlling buck output by a CTRL_PIN. In the
following diagram, there is a static settings on vosel_sleep for suspend
mode output. According to CTRL_PIN's level, Vout can have different
output (voselon or vosel_sleep). 

           +------------------------------------------------------+
           |    MT6397                                            |
           |                              -vosel     -            |
CTRL_PIN   |     +-----------------+                  \ + nivosel-|-Vout
-----------|-----| hardware control|---+  -voselon   -            |
           |     +-----------------+    \ -vosel_sleep -          |
           |                                                      |
           +------------------------------------------------------+

In the design, voltage change on bucks are set both on registers vosel
and voselon. I will add more comments on the function to clarify the
implementation. 

Thanks, 
Flora