From mboxrd@z Thu Jan 1 00:00:00 1970 From: balbi@ti.com (Felipe Balbi) Date: Thu, 4 Dec 2014 09:10:21 -0600 Subject: [PATCH] arm: boot: dts: am437x-sk: fix lcd enable pin mux data In-Reply-To: <20141204144325.GA17269@saruman> References: <20141204144325.GA17269@saruman> Message-ID: <1417705821-21847-1-git-send-email-balbi@ti.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Caused by a copy & paste error. Note that even with this bug AM437x SK display still works because GPIO mux mode is always enabled. It's still wrong to mux somebody else's pin. Luckily ball D25 (offset 0x238 - gpio5_8) on AM437x isn't used for anything. While at that, also replace a pullup with a pulldown as that gpio should be normally low, not high. Cc: # v3.17+ Acked-by: Tomi Valkeinen Signed-off-by: Felipe Balbi --- arch/arm/boot/dts/am437x-sk-evm.dts | 3 +-- 1 file changed, 1 insertion(+), 2 deletions(-) diff --git a/arch/arm/boot/dts/am437x-sk-evm.dts b/arch/arm/boot/dts/am437x-sk-evm.dts index f7f77a7..0eceb8a 100644 --- a/arch/arm/boot/dts/am437x-sk-evm.dts +++ b/arch/arm/boot/dts/am437x-sk-evm.dts @@ -320,8 +320,7 @@ lcd_pins: lcd_pins { pinctrl-single,pins = < - /* GPIO 5_8 to select LCD / HDMI */ - 0x238 (PIN_OUTPUT_PULLUP | MUX_MODE7) + 0x1c (PIN_OUTPUT_PULLDOWN | MUX_MODE7) /* gpcm_ad7.gpio1_7 */ >; }; }; -- 2.1.0.GIT