From: hanjun.guo@linaro.org (Hanjun Guo)
To: linux-arm-kernel@lists.infradead.org
Subject: [PATCH v6 16/17] ARM64 / ACPI: Enable ARM64 in Kconfig
Date: Sun, 4 Jan 2015 18:55:17 +0800 [thread overview]
Message-ID: <1420368918-5086-17-git-send-email-hanjun.guo@linaro.org> (raw)
In-Reply-To: <1420368918-5086-1-git-send-email-hanjun.guo@linaro.org>
From: Graeme Gregory <graeme.gregory@linaro.org>
Add Kconfigs to build ACPI on ARM64, and make ACPI available on ARM64.
acpi_idle driver is x86/IA64 dependent now, so make CONFIG_ACPI_PROCESSOR
depend on X86 || IA64, and implement it on ARM64 in the future.
Reviewed-by: Grant Likely <grant.likely@linaro.org>
Tested-by: Suravee Suthikulpanit <Suravee.Suthikulpanit@amd.com>
Signed-off-by: Graeme Gregory <graeme.gregory@linaro.org>
Signed-off-by: Al Stone <al.stone@linaro.org>
Signed-off-by: Hanjun Guo <hanjun.guo@linaro.org>
---
arch/arm64/Kconfig | 2 ++
drivers/acpi/Kconfig | 6 +++---
2 files changed, 5 insertions(+), 3 deletions(-)
diff --git a/arch/arm64/Kconfig b/arch/arm64/Kconfig
index c19ae5d..915aa16 100644
--- a/arch/arm64/Kconfig
+++ b/arch/arm64/Kconfig
@@ -647,6 +647,8 @@ source "drivers/Kconfig"
source "drivers/firmware/Kconfig"
+source "drivers/acpi/Kconfig"
+
source "fs/Kconfig"
source "arch/arm64/kvm/Kconfig"
diff --git a/drivers/acpi/Kconfig b/drivers/acpi/Kconfig
index 8951cef..3e3bd35 100644
--- a/drivers/acpi/Kconfig
+++ b/drivers/acpi/Kconfig
@@ -5,8 +5,7 @@
menuconfig ACPI
bool "ACPI (Advanced Configuration and Power Interface) Support"
depends on !IA64_HP_SIM
- depends on IA64 || X86
- depends on PCI
+ depends on ((IA64 || X86) && PCI) || (ARM64 && EXPERT)
select PNP
default y
help
@@ -163,6 +162,7 @@ config ACPI_PROCESSOR
tristate "Processor"
select THERMAL
select CPU_IDLE
+ depends on X86 || IA64
default y
help
This driver installs ACPI as the idle handler for Linux and uses
@@ -263,7 +263,7 @@ config ACPI_DEBUG
config ACPI_PCI_SLOT
bool "PCI slot detection driver"
- depends on SYSFS
+ depends on SYSFS && PCI
default n
help
This driver creates entries in /sys/bus/pci/slots/ for all PCI
--
1.9.1
next prev parent reply other threads:[~2015-01-04 10:55 UTC|newest]
Thread overview: 35+ messages / expand[flat|nested] mbox.gz Atom feed top
2015-01-04 10:55 [PATCH v6 00/17] Introduce ACPI for ARM64 based on ACPI 5.1 Hanjun Guo
2015-01-04 10:55 ` [PATCH v6 01/17] ACPI / processor: Convert apic_id to phys_id to make it arch agnostic Hanjun Guo
2015-01-07 1:50 ` Rafael J. Wysocki
2015-01-07 9:49 ` Hanjun Guo
2015-01-04 10:55 ` [PATCH v6 02/17] ACPI / processor: Rename acpi_(un)map_lsapic() to acpi_(un)map_cpu() Hanjun Guo
2015-01-04 10:55 ` [PATCH v6 03/17] ARM64 / ACPI: Get RSDP and ACPI boot-time tables Hanjun Guo
2015-01-04 10:55 ` [PATCH v6 04/17] ARM64 / ACPI: Introduce sleep-arm.c Hanjun Guo
2015-01-04 10:55 ` [PATCH v6 05/17] ARM64 / ACPI: Introduce early_param for "acpi" and pass acpi=force to enable ACPI Hanjun Guo
2015-01-04 10:55 ` [PATCH v6 06/17] ARM64 / ACPI: If we chose to boot from acpi then disable FDT Hanjun Guo
2015-01-04 10:55 ` [PATCH v6 07/17] ARM64 / ACPI: Make PCI optional for ACPI on ARM64 Hanjun Guo
2015-01-04 10:55 ` [PATCH v6 08/17] ARM64 / ACPI: Parse FADT table to get PSCI flags for PSCI init Hanjun Guo
2015-01-09 19:04 ` Lorenzo Pieralisi
2015-01-12 4:26 ` Hanjun Guo
2015-01-12 11:41 ` Lorenzo Pieralisi
2015-01-13 6:54 ` Hanjun Guo
2015-01-04 10:55 ` [PATCH v6 09/17] ACPI / table: Print GIC information when MADT is parsed Hanjun Guo
2015-01-04 10:55 ` [PATCH v6 10/17] ARM64 / ACPI: Parse MADT for SMP initialization Hanjun Guo
2015-01-04 10:55 ` [PATCH v6 11/17] ACPI / processor: Make it possible to get CPU hardware ID via GICC Hanjun Guo
2015-01-04 10:55 ` [PATCH v6 12/17] ARM64 / ACPI: Introduce ACPI_IRQ_MODEL_GIC and register device's gsi Hanjun Guo
2015-01-04 10:55 ` [PATCH v6 13/17] ARM64 / ACPI: Add GICv2 specific ACPI boot support Hanjun Guo
2015-01-04 10:55 ` [PATCH v6 14/17] ARM64 / ACPI: Parse GTDT to initialize arch timer Hanjun Guo
2015-01-05 7:55 ` Suthikulpanit, Suravee
2015-01-05 8:59 ` Hanjun Guo
2015-01-04 10:55 ` [PATCH v6 15/17] ARM64 / ACPI: Select ACPI_REDUCED_HARDWARE_ONLY if ACPI is enabled on ARM64 Hanjun Guo
2015-01-04 10:55 ` Hanjun Guo [this message]
2015-01-04 10:55 ` [PATCH v6 17/17] Documentation: ACPI for ARM64 Hanjun Guo
2015-01-06 9:52 ` 答复: " liyi 00215672
2015-01-06 11:21 ` Hanjun Guo
2015-01-06 20:49 ` Arnd Bergmann
2015-01-19 20:33 ` Christoffer Dall
2015-01-21 12:37 ` Hanjun Guo
2015-01-21 13:03 ` Stefano Stabellini
2015-01-21 16:04 ` Christoffer Dall
2015-01-06 7:05 ` [PATCH v6 00/17] Introduce ACPI for ARM64 based on ACPI 5.1 Yijing Wang
2015-01-06 11:17 ` Hanjun Guo
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1420368918-5086-17-git-send-email-hanjun.guo@linaro.org \
--to=hanjun.guo@linaro.org \
--cc=linux-arm-kernel@lists.infradead.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).