From mboxrd@z Thu Jan 1 00:00:00 1970 From: daniel.thompson@linaro.org (Daniel Thompson) Date: Mon, 5 Jan 2015 12:40:19 +0000 Subject: [PATCH 3.19-rc2 v15 3/8] arm: Remove DEBUG_LL_UART_NONE In-Reply-To: <1420461624-4410-1-git-send-email-daniel.thompson@linaro.org> References: <1420461624-4410-1-git-send-email-daniel.thompson@linaro.org> Message-ID: <1420461624-4410-4-git-send-email-daniel.thompson@linaro.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Only a very small handful of platforms support DEBUG_LL_UART_NONE but it lurks in the menus of every single platform config ready to break the build. This is an especial problem for defconfig/oldconfig since it is often selected by default. This patch solves the problem by removing this option. Any platforms still depending upon this option must be migrated. Signed-off-by: Daniel Thompson Cc: Russell King --- arch/arm/Kconfig.debug | 9 --------- 1 file changed, 9 deletions(-) diff --git a/arch/arm/Kconfig.debug b/arch/arm/Kconfig.debug index c5648cc1466d..6ee9b0d361ee 100644 --- a/arch/arm/Kconfig.debug +++ b/arch/arm/Kconfig.debug @@ -1031,15 +1031,6 @@ choice This option selects UART0 on VIA/Wondermedia System-on-a-chip devices, including VT8500, WM8505, WM8650 and WM8850. - config DEBUG_LL_UART_NONE - bool "No low-level debugging UART" - depends on !ARCH_MULTIPLATFORM - help - Say Y here if your platform doesn't provide a UART option - above. This relies on your platform choosing the right UART - definition internally in order for low-level debugging to - work. - config DEBUG_ICEDCC bool "Kernel low-level debugging via EmbeddedICE DCC channel" help -- 1.9.3