From mboxrd@z Thu Jan 1 00:00:00 1970 From: marc.zyngier@arm.com (Marc Zyngier) Date: Wed, 7 Jan 2015 17:42:46 +0000 Subject: [PATCH v2 11/21] DT: arm,gic: kill arm,routable-irqs In-Reply-To: <1420652576-22309-1-git-send-email-marc.zyngier@arm.com> References: <1420652576-22309-1-git-send-email-marc.zyngier@arm.com> Message-ID: <1420652576-22309-12-git-send-email-marc.zyngier@arm.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Nobody will regret it. Signed-off-by: Marc Zyngier --- Documentation/devicetree/bindings/arm/gic.txt | 6 ------ 1 file changed, 6 deletions(-) diff --git a/Documentation/devicetree/bindings/arm/gic.txt b/Documentation/devicetree/bindings/arm/gic.txt index 8112d0c..631cb71 100644 --- a/Documentation/devicetree/bindings/arm/gic.txt +++ b/Documentation/devicetree/bindings/arm/gic.txt @@ -52,11 +52,6 @@ Optional regions, used when the GIC doesn't have banked registers. The offset is cpu-offset * cpu-nr. -- arm,routable-irqs : Total number of gic irq inputs which are not directly - connected from the peripherals, but are routed dynamically - by a crossbar/multiplexer preceding the GIC. The GIC irq - input line is assigned dynamically when the corresponding - peripheral's crossbar line is mapped. Example: intc: interrupt-controller at fff11000 { @@ -64,7 +59,6 @@ Example: #interrupt-cells = <3>; #address-cells = <1>; interrupt-controller; - arm,routable-irqs = <160>; reg = <0xfff11000 0x1000>, <0xfff10100 0x100>; }; -- 2.1.4