From mboxrd@z Thu Jan 1 00:00:00 1970 From: wens@csie.org (Chen-Yu Tsai) Date: Tue, 3 Mar 2015 10:21:57 +0800 Subject: [PATCH 0/3] ARM: sun9i: Add support for PRCM on Allwinner A80 SoC Message-ID: <1425349320-2754-1-git-send-email-wens@csie.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Hi everyone, Some time ago I sent out an RFC series, which was not merged due to lack of matching documentation for the SoC. A few weeks back I sent out a request for the documents again. I have not received a response. So I'm sending out the series now. This series adds support for the Power Reset and Clock Management module on Allwinner's A80 SoC. The PRCM manages clocks and resets for the "special" block of peripherals, or the R/RTC block in earlier SoCs. These peripherals include a standby processor core, a timer block, a watchdog, pin controller, 1 wire interface, PS/2 interface, a UART, the RSB controller, a DMA controller, a consumer IR receiver block, 2 I2C controllers, and 2 I2S controllers. We do not have documents for all the peripherals. Support will be added where possible. Patch 1 adds support for the apbs (apb0 in earlier SoCs) gates. Patch 2 adds sun9i-a80 support to the PRCM mfd driver Patch 3 adds the clock and reset nodes for the PRCM to the A80 DTSI. To Allwinner people: If you have any related documents or comments, please send them out. Regards, ChenYu Chen-Yu Tsai (3): clk: sunxi: sun6i-apb0: Add support for sun9i A80 apbs gates mfd: sun6i-prcm: Add support for PRCM found on Allwinner A80 SoC ARM: dts: sun9i: Add A80 PRCM clocks and reset control nodes Documentation/devicetree/bindings/clock/sunxi.txt | 1 + .../devicetree/bindings/mfd/sun6i-prcm.txt | 3 +- arch/arm/boot/dts/sun9i-a80.dtsi | 54 +++++++++++++++++++- drivers/clk/sunxi/clk-sun6i-apb0-gates.c | 6 +++ drivers/mfd/sun6i-prcm.c | 58 ++++++++++++++++++++++ 5 files changed, 120 insertions(+), 2 deletions(-) -- 2.1.4