[PATCH] dmaengine: omap-dma: Add support for memcpy

[PATCH] dmaengine: omap-dma: Add support for memcpy

[Peter Ujfalusi]

The sDMA controller is capable of performing memory copy operation. It need
to be configured to software triggered mode and without HW synchronization.
The sDMA can copy data which is aligned to 8, 16 or 32 bits.

Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
---
 drivers/dma/omap-dma.c | 51 ++++++++++++++++++++++++++++++++++++++++++++++++--
 1 file changed, 49 insertions(+), 2 deletions(-)

diff --git a/drivers/dma/omap-dma.c b/drivers/dma/omap-dma.c
index 36e6a299af5c..1dfc71c90123 100644
--- a/drivers/dma/omap-dma.c
+++ b/drivers/dma/omap-dma.c
@@ -366,7 +366,7 @@ static void omap_dma_start_sg(struct omap_chan *c, struct omap_desc *d,
 	struct omap_sg *sg = d->sg + idx;
 	unsigned cxsa, cxei, cxfi;
 
-	if (d->dir == DMA_DEV_TO_MEM) {
+	if (d->dir == DMA_DEV_TO_MEM || d->dir == DMA_MEM_TO_MEM) {
 		cxsa = CDSA;
 		cxei = CDEI;
 		cxfi = CDFI;
@@ -412,7 +412,7 @@ static void omap_dma_start_desc(struct omap_chan *c)
 	if (dma_omap1())
 		omap_dma_chan_write(c, CCR2, d->ccr >> 16);
 
-	if (d->dir == DMA_DEV_TO_MEM) {
+	if (d->dir == DMA_DEV_TO_MEM || d->dir == DMA_MEM_TO_MEM) {
 		cxsa = CSSA;
 		cxei = CSEI;
 		cxfi = CSFI;
@@ -957,6 +957,51 @@ static struct dma_async_tx_descriptor *omap_dma_prep_dma_cyclic(
 	return vchan_tx_prep(&c->vc, &d->vd, flags);
 }
 
+static struct dma_async_tx_descriptor *omap_dma_prep_dma_memcpy(
+	struct dma_chan *chan, dma_addr_t dest, dma_addr_t src,
+	size_t len, unsigned long tx_flags)
+{
+	struct omap_chan *c = to_omap_dma_chan(chan);
+	struct omap_desc *d;
+	uint8_t data_type;
+
+	d = kzalloc(sizeof(*d) + sizeof(d->sg[0]), GFP_ATOMIC);
+	if (!d)
+		return NULL;
+
+	data_type = __ffs((src | dest | len));
+	if (data_type > CSDP_DATA_TYPE_32)
+		data_type = CSDP_DATA_TYPE_32;
+
+	d->dir = DMA_MEM_TO_MEM;
+	d->dev_addr = src;
+	d->fi = 0;
+	d->es = data_type;
+	d->sg[0].en = len / BIT(data_type);
+	d->sg[0].fn = 1;
+	d->sg[0].addr = dest;
+	d->sglen = 1;
+	d->ccr = c->ccr;
+	d->ccr |= CCR_DST_AMODE_POSTINC | CCR_SRC_AMODE_POSTINC;
+
+	d->cicr = CICR_DROP_IE;
+	if (tx_flags & DMA_PREP_INTERRUPT)
+		d->cicr |= CICR_FRAME_IE;
+
+	d->csdp = data_type;
+
+	if (dma_omap1()) {
+		d->cicr |= CICR_TOUT_IE;
+		d->csdp |= CSDP_DST_PORT_EMIFF | CSDP_SRC_PORT_EMIFF;
+	} else {
+		d->csdp |= CSDP_DST_PACKED | CSDP_SRC_PACKED;
+		d->cicr |= CICR_MISALIGNED_ERR_IE | CICR_TRANS_ERR_IE;
+		d->csdp |= CSDP_DST_BURST_64 | CSDP_SRC_BURST_64;
+	}
+
+	return vchan_tx_prep(&c->vc, &d->vd, tx_flags);
+}
+
 static int omap_dma_slave_config(struct dma_chan *chan, struct dma_slave_config *cfg)
 {
 	struct omap_chan *c = to_omap_dma_chan(chan);
@@ -1102,12 +1147,14 @@ static int omap_dma_probe(struct platform_device *pdev)
 
 	dma_cap_set(DMA_SLAVE, od->ddev.cap_mask);
 	dma_cap_set(DMA_CYCLIC, od->ddev.cap_mask);
+	dma_cap_set(DMA_MEMCPY, od->ddev.cap_mask);
 	od->ddev.device_alloc_chan_resources = omap_dma_alloc_chan_resources;
 	od->ddev.device_free_chan_resources = omap_dma_free_chan_resources;
 	od->ddev.device_tx_status = omap_dma_tx_status;
 	od->ddev.device_issue_pending = omap_dma_issue_pending;
 	od->ddev.device_prep_slave_sg = omap_dma_prep_slave_sg;
 	od->ddev.device_prep_dma_cyclic = omap_dma_prep_dma_cyclic;
+	od->ddev.device_prep_dma_memcpy = omap_dma_prep_dma_memcpy;
 	od->ddev.device_config = omap_dma_slave_config;
 	od->ddev.device_pause = omap_dma_pause;
 	od->ddev.device_resume = omap_dma_resume;
-- 
2.3.5

[PATCH] dmaengine: omap-dma: Add support for memcpy

[Vinod Koul]

On Wed, Apr 22, 2015 at 10:34:29AM +0300, Peter Ujfalusi wrote:
> The sDMA controller is capable of performing memory copy operation. It need
> to be configured to software triggered mode and without HW synchronization.
> The sDMA can copy data which is aligned to 8, 16 or 32 bits.
Applied, thanks

-- 
~Vinod

[PATCH] dmaengine: omap-dma: Add support for memcpy

[Laurent Pinchart]

Hi Peter,

Thank you for the patch.

While trying to port the omap_vout driver to the DMA engine API I noticed that 
the driver makes use of double-indexed transfers, which are not supported by 
the omap-dma driver. I haven't checked in details what would be required, but 
the interleaved API might be a good candidate for this. Do you have any plan 
to add support for double-indexed transfers to the omap-dma driver ?

On Wednesday 22 April 2015 10:34:29 Peter Ujfalusi wrote:
> The sDMA controller is capable of performing memory copy operation. It need
> to be configured to software triggered mode and without HW synchronization.
> The sDMA can copy data which is aligned to 8, 16 or 32 bits.
> 
> Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
> ---
>  drivers/dma/omap-dma.c | 51 +++++++++++++++++++++++++++++++++++++++++++++--
>  1 file changed, 49 insertions(+), 2 deletions(-)

-- 
Regards,

Laurent Pinchart

[PATCH] dmaengine: omap-dma: Add support for memcpy

[Peter Ujfalusi]

Laurent,

On 09/08/2015 02:24 PM, Laurent Pinchart wrote:
> Hi Peter,
> 
> Thank you for the patch.
> 
> While trying to port the omap_vout driver to the DMA engine API I noticed that 
> the driver makes use of double-indexed transfers, which are not supported by 
> the omap-dma driver. I haven't checked in details what would be required, but 
> the interleaved API might be a good candidate for this. Do you have any plan 
> to add support for double-indexed transfers to the omap-dma driver ?

If double-indexed transfer support is needed by drivers still using the
legacy/direct sDMA API, then I don't think we have other options..
So far I have not looked at that part and where it would fit.
I'll try to find time to look at this. I hope not in the distant future ;)

> On Wednesday 22 April 2015 10:34:29 Peter Ujfalusi wrote:
>> The sDMA controller is capable of performing memory copy operation. It need
>> to be configured to software triggered mode and without HW synchronization.
>> The sDMA can copy data which is aligned to 8, 16 or 32 bits.
>>
>> Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
>> ---
>>  drivers/dma/omap-dma.c | 51 +++++++++++++++++++++++++++++++++++++++++++++--
>>  1 file changed, 49 insertions(+), 2 deletions(-)
> 

-- 
P?ter