From mboxrd@z Thu Jan 1 00:00:00 1970 From: lee.jones@linaro.org (Lee Jones) Date: Tue, 12 May 2015 13:51:40 +0100 Subject: [PATCH 03/13] ARM: STi: STiH416: Add DT nodes for PWM In-Reply-To: <1431435110-22595-1-git-send-email-lee.jones@linaro.org> References: <1431435110-22595-1-git-send-email-lee.jones@linaro.org> Message-ID: <1431435110-22595-4-git-send-email-lee.jones@linaro.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Supply top level nodes for the STiH416 based development boards. The Pinctrl configuration has already been applied, so the only missing piece of the DT puzzle is for a board's DTB to enable the nodes. Signed-off-by: Ajit Pal Singh Signed-off-by: Lee Jones --- arch/arm/boot/dts/stih416.dtsi | 44 +++++++++++++++++++++++++++++++++++++++++- 1 file changed, 43 insertions(+), 1 deletion(-) diff --git a/arch/arm/boot/dts/stih416.dtsi b/arch/arm/boot/dts/stih416.dtsi index eeb7afe..9ead8bb 100644 --- a/arch/arm/boot/dts/stih416.dtsi +++ b/arch/arm/boot/dts/stih416.dtsi @@ -104,7 +104,7 @@ interrupts = <0 210 0>; pinctrl-names = "default"; pinctrl-0 = <&pinctrl_sbc_serial1>; - clocks = <&clk_sysin>; + clocks = <&clk_sysin>; }; i2c at fed40000 { @@ -445,5 +445,47 @@ <&softreset STIH416_USB3_SOFTRESET>; reset-names = "power", "softreset"; }; + + /* SAS PWM Module */ + pwm0: pwm at fed10000 { + compatible = "st,sti-pwm"; + status = "disabled"; + #pwm-cells = <2>; + reg = <0xfed10000 0x68>; + + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_pwm0_chan0_default + &pinctrl_pwm0_chan1_default + &pinctrl_pwm0_chan2_default + &pinctrl_pwm0_chan3_default>; + + clock-names = "pwm"; + clocks = <&clk_sysin>; + st,pwm-num-chan = <4>; + }; + + /* SBC PWM Module */ + pwm1: pwm at fe510000 { + compatible = "st,sti-pwm"; + status = "disabled"; + #pwm-cells = <2>; + reg = <0xfe510000 0x68>; + + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_pwm1_chan0_default + /* + * Shared with SBC_OBS_NOTRST. Don't + * enable unless you really know what + * you're doing. + * + * &pinctrl_pwm1_chan1_default + */ + &pinctrl_pwm1_chan2_default + &pinctrl_pwm1_chan3_default>; + + clock-names = "pwm"; + clocks = <&clk_sysin>; + st,pwm-num-chan = <3>; + }; }; }; -- 1.9.1