From mboxrd@z Thu Jan 1 00:00:00 1970 From: s.hauer@pengutronix.de (Sascha Hauer) Date: Wed, 13 May 2015 10:52:41 +0200 Subject: [PATCH 13/15] dt-bindings: thermal: Add binding document for Mediatek thermal controller In-Reply-To: <1431507163-19933-1-git-send-email-s.hauer@pengutronix.de> References: <1431507163-19933-1-git-send-email-s.hauer@pengutronix.de> Message-ID: <1431507163-19933-14-git-send-email-s.hauer@pengutronix.de> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Signed-off-by: Sascha Hauer --- .../bindings/thermal/mediatek-thermal.txt | 36 ++++++++++++++++++++++ 1 file changed, 36 insertions(+) create mode 100644 Documentation/devicetree/bindings/thermal/mediatek-thermal.txt diff --git a/Documentation/devicetree/bindings/thermal/mediatek-thermal.txt b/Documentation/devicetree/bindings/thermal/mediatek-thermal.txt new file mode 100644 index 0000000..adf5d2c --- /dev/null +++ b/Documentation/devicetree/bindings/thermal/mediatek-thermal.txt @@ -0,0 +1,36 @@ +* Mediatek Thermal + +This describes the device tree binding for the Mediatek thermal controller +which measures the on-SoC temperatures. This device does not have its own ADC, +instead it directly controls the AUXADC via AHB bus accesses. For this reason +this device needs phandles to the AUXADC. + +Required properties: +- compatible: "mediatek,mt8173-thermal" +- reg: Address range of the thermal controller +- interrupts: IRQ for the thermal controller +- clocks, clock-names: Clocks needed for the thermal controller. required + clocks are: + "therm": Main clock needed for register access + "auxadc": The AUXADC clock +- resets, reset-names: Reference to the reset controller controlling the thermal + controller. Required reset-names: + "therm": The main reset line +- auxadc: A phandle to the AUXADC which the thermal controller uses +- apmixedsys: A phandle to the APMIXEDSYS controller. +- #thermal-sensor-cells : Should be 1. See ./thermal.txt for a description + +Example: + + thermal: thermal at 1100b000 { + #thermal-sensor-cells = <1>; + compatible = "mediatek,mt8173-thermal"; + reg = <0 0x1100b000 0 0x1000>; + interrupts = <0 70 IRQ_TYPE_LEVEL_LOW>; + clocks = <&pericfg CLK_PERI_THERM>, <&pericfg CLK_PERI_AUXADC>; + clock-names = "therm", "auxadc"; + resets = <&pericfg MT8173_PERI_THERM_SW_RST>; + reset-names = "therm"; + auxadc = <&auxadc>; + apmixedsys = <&apmixedsys>; + }; -- 2.1.4