From mboxrd@z Thu Jan 1 00:00:00 1970 From: ivan.ivanov@linaro.org (Ivan T. Ivanov) Date: Thu, 4 Jun 2015 12:19:05 +0300 Subject: [PATCH 6/7] arm64: dts: qcom: Fix apq8016-sbc board USB related pin definitions In-Reply-To: <1433409546-23995-1-git-send-email-ivan.ivanov@linaro.org> References: <1433409546-23995-1-git-send-email-ivan.ivanov@linaro.org> Message-ID: <1433409546-23995-7-git-send-email-ivan.ivanov@linaro.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org USB2513B HUB reset line is connected to PMIC GPIO3 not GPIO1. Fix TC7USB40MU Dual SPDT Switch select input line control, which is connected to PMIC GPIO4 not GPIO2 and disable the pin. It is not used for now. Remove user LEDs definitions, because they clash with above numbers. Signed-off-by: Ivan T. Ivanov --- .../arm64/boot/dts/qcom/apq8016-sbc-pmic-pins.dtsi | 22 ++++++++-------------- 1 file changed, 8 insertions(+), 14 deletions(-) diff --git a/arch/arm64/boot/dts/qcom/apq8016-sbc-pmic-pins.dtsi b/arch/arm64/boot/dts/qcom/apq8016-sbc-pmic-pins.dtsi index 37ca2ed..b568c49 100644 --- a/arch/arm64/boot/dts/qcom/apq8016-sbc-pmic-pins.dtsi +++ b/arch/arm64/boot/dts/qcom/apq8016-sbc-pmic-pins.dtsi @@ -2,26 +2,20 @@ &pm8916_gpios { - pm8916_gpios_default: default { - usb_hub_reset_pm { - pins = "gpio1"; - function = PMIC_GPIO_FUNC_NORMAL; - output-low; - }; - usb_sw_sel_pm { - pins = "gpio2"; - function = PMIC_GPIO_FUNC_NORMAL; - input-disable; - }; - usr_led_3_ctrl { + usb_hub_reset_pm: usb_hub_reset_pm { + pinconf { pins = "gpio3"; function = PMIC_GPIO_FUNC_NORMAL; output-low; }; - usr_led_4_ctrl { + }; + + usb_sw_sel_pm: usb_sw_sel_pm { + pinconf { pins = "gpio4"; function = PMIC_GPIO_FUNC_NORMAL; - output-low; + power-source = ; + input-disable; }; }; }; -- 1.9.1