[PATCH V4 0/7] i2c: qup: Add support for v2 tags and bam dma

[sricharan@codeaurora.org (Sricharan R)]

QUP from version 2.1.1 onwards, supports a new format of i2c command tags.
Tag codes instructs the controller to perform a operation like read/write.
This new tagging version supports and is required for adding bam dma
capabilities. V2 tags supports transfer of more than 256 bytes in a single
i2c transaction. Also adding bam dma support facilitates transferring each
i2c_msg in i2c_msgs without a 'stop' bit in between which is required for some
of the clients.

Tested this series on apq8074 dragon board eeprom client on i2c bus1

[V4] Added a patch to factor out some common code.
     Removed support for freq > 400KHZ as per comments.
     Addressed comments from Ivan T. Ivanov to keep the code for
     V2 support in a separate path. 
     Changed the authorship of V2 tags support patch.

[V3] Added support to coalesce each i2c_msg in i2c_msgs for fifo and
     block mode in Patch 2. Also addressed further code comments.

     http://comments.gmane.org/gmane.linux.drivers.i2c/22497

[V2] Addressed comments from Ivan T. Ivanov, Andy Gross [v1] Initial Version

Sricharan R (7):
  i2c: qup: Change qup_wait_writeready function to use for all timeouts
  qup: i2c: factor out common code for reuse
  i2c: qup: Add V2 tags support
  i2c: qup: Transfer each i2c_msg in i2c_msgs without a stop bit
  i2c: qup: Add bam dma capabilities
  dts: msm8974: Add blsp2_bam dma node
  dts: msm8974: Add dma channels for blsp2_i2c1 node

 arch/arm/boot/dts/qcom-msm8974.dtsi |  14 +-
 drivers/i2c/busses/i2c-qup.c        | 943 +++++++++++++++++++++++++++++++++---
 2 files changed, 880 insertions(+), 77 deletions(-)

-- 
QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum, hosted by The Linux Foundation