From mboxrd@z Thu Jan 1 00:00:00 1970 From: vaibhav.hiremath@linaro.org (Vaibhav Hiremath) Date: Tue, 21 Jul 2015 18:11:02 +0530 Subject: [PATCH-v5 1/5] Documentation: binding: add new property 'disable_after_xfer' to i2c-pxa In-Reply-To: <1437482466-16126-1-git-send-email-vaibhav.hiremath@linaro.org> References: <1437482466-16126-1-git-send-email-vaibhav.hiremath@linaro.org> Message-ID: <1437482466-16126-2-git-send-email-vaibhav.hiremath@linaro.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Driver will now supports enable/disable across msg xfer, which user can control it by new DT property - i2c-disable-after-xfer : If set, driver will disable I2C module after msg xfer and enable it back before xfer. Signed-off-by: Vaibhav Hiremath --- Documentation/devicetree/bindings/i2c/i2c-pxa.txt | 5 +++++ 1 file changed, 5 insertions(+) diff --git a/Documentation/devicetree/bindings/i2c/i2c-pxa.txt b/Documentation/devicetree/bindings/i2c/i2c-pxa.txt index 12b78ac..9657db5 100644 --- a/Documentation/devicetree/bindings/i2c/i2c-pxa.txt +++ b/Documentation/devicetree/bindings/i2c/i2c-pxa.txt @@ -18,6 +18,11 @@ Recommended properties : status register of i2c controller instead. - mrvl,i2c-fast-mode : Enable fast mode of i2c controller. +Optional properties : + + - i2c-disable-after-xfer : If set, driver will disable I2C module + after msg xfer and enable it again before xfer. + Examples: twsi1: i2c at d4011000 { compatible = "mrvl,mmp-twsi"; -- 1.9.1