From mboxrd@z Thu Jan 1 00:00:00 1970 From: ard.biesheuvel@linaro.org (Ard Biesheuvel) Date: Mon, 16 Nov 2015 11:18:14 +0100 Subject: [PATCH] arm64: mm: use correct mapping granularity under DEBUG_RODATA Message-ID: <1447669094-31076-1-git-send-email-ard.biesheuvel@linaro.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org When booting a 64k pages kernel that is built with CONFIG_DEBUG_RODATA and resides at an offset that is not a multiple of 512 MB, the rounding that occurs in __map_memblock() and fixup_executable() results in incorrect regions being mapped. The following snippet from /sys/kernel/debug/kernel_page_tables shows how, when the kernel is loaded 2 MB above the base of DRAM at 0x40000000, the first 2 MB of memory (which may be inaccessible from non-secure EL1 or just reserved by the firmware) is inadvertently mapped into the end of the module region. ---[ Modules start ]--- 0xfffffdffffe00000-0xfffffe0000000000 2M RW NX ... UXN MEM/NORMAL ---[ Modules end ]--- ---[ Kernel Mapping ]--- 0xfffffe0000000000-0xfffffe0000090000 576K RW NX ... UXN MEM/NORMAL 0xfffffe0000090000-0xfffffe0000200000 1472K ro x ... UXN MEM/NORMAL 0xfffffe0000200000-0xfffffe0000800000 6M ro x ... UXN MEM/NORMAL 0xfffffe0000800000-0xfffffe0000810000 64K ro x ... UXN MEM/NORMAL 0xfffffe0000810000-0xfffffe0000a00000 1984K RW NX ... UXN MEM/NORMAL 0xfffffe0000a00000-0xfffffe00ffe00000 4084M RW NX ... UXN MEM/NORMAL The same issue is likely to occur on 16k pages kernels whose load address is not a multiple of 32 MB (i.e., SECTION_SIZE). So round to SWAPPER_BLOCK_SIZE instead of SECTION_SIZE. Signed-off-by: Ard Biesheuvel --- arch/arm64/mm/mmu.c | 12 ++++++------ 1 file changed, 6 insertions(+), 6 deletions(-) diff --git a/arch/arm64/mm/mmu.c b/arch/arm64/mm/mmu.c index e3f563c81c48..32ddd893da9a 100644 --- a/arch/arm64/mm/mmu.c +++ b/arch/arm64/mm/mmu.c @@ -362,8 +362,8 @@ static void __init __map_memblock(phys_addr_t start, phys_addr_t end) * for now. This will get more fine grained later once all memory * is mapped */ - unsigned long kernel_x_start = round_down(__pa(_stext), SECTION_SIZE); - unsigned long kernel_x_end = round_up(__pa(__init_end), SECTION_SIZE); + unsigned long kernel_x_start = round_down(__pa(_stext), SWAPPER_BLOCK_SIZE); + unsigned long kernel_x_end = round_up(__pa(__init_end), SWAPPER_BLOCK_SIZE); if (end < kernel_x_start) { create_mapping(start, __phys_to_virt(start), @@ -451,18 +451,18 @@ static void __init fixup_executable(void) { #ifdef CONFIG_DEBUG_RODATA /* now that we are actually fully mapped, make the start/end more fine grained */ - if (!IS_ALIGNED((unsigned long)_stext, SECTION_SIZE)) { + if (!IS_ALIGNED((unsigned long)_stext, SWAPPER_BLOCK_SIZE)) { unsigned long aligned_start = round_down(__pa(_stext), - SECTION_SIZE); + SWAPPER_BLOCK_SIZE); create_mapping(aligned_start, __phys_to_virt(aligned_start), __pa(_stext) - aligned_start, PAGE_KERNEL); } - if (!IS_ALIGNED((unsigned long)__init_end, SECTION_SIZE)) { + if (!IS_ALIGNED((unsigned long)__init_end, SWAPPER_BLOCK_SIZE)) { unsigned long aligned_end = round_up(__pa(__init_end), - SECTION_SIZE); + SWAPPER_BLOCK_SIZE); create_mapping(__pa(__init_end), (unsigned long)__init_end, aligned_end - __pa(__init_end), PAGE_KERNEL); -- 1.9.1