From: lee.jones@linaro.org (Lee Jones)
To: linux-arm-kernel@lists.infradead.org
Subject: [PATCH v5 0/7] remoteproc: Add driver for STMicroelectronics platforms
Date: Tue, 12 Jan 2016 12:46:14 +0000 [thread overview]
Message-ID: <1452602781-22424-1-git-send-email-lee.jones@linaro.org> (raw)
ST's platforms often have multiple co-processors (usually ST40s or ST231s)
on-board. This provides the Linux-side infrastructure to flash and boot
them successfully.
This set has been tested on an STiH410-B2120.
v4 => v5:
- Check for invalid 'count' (command read length) in write fn()s
v3 => v4:
Suggested-by: Suman Anna <s-anna@ti.com>
- Move to using 'reserved-memory' API
- New 'reserved-memory' nodes
- Remove memory locations from RemoteProc's DT node's reg properties
- Remove C code obtaining/allocating DMA memory
- Re-order .start() and .stop() ops
- Add protection around Reset API in error path
- Explicitly set .has_iommu to false
v2 => v3:
- Generify syscon property (st,syscfg-boot => st,syscfg)
- Rename IP in DT bindings doc (Remote Processor => Co-Processor)
- Remove superfluous 'clock-names' property
- Remove superfluous 'reg-names' property
- Populate MAINTAINERS
- Clean-up DTS formatting
- Use strings in debugfs to control procs ('1|0' => 'start|stop')
- Align copyright statement with MODULE() macros
- Rename driver data structure ('st_rproc' => 'ddata')
- Addition of a full error path in .start()
v1 => v2:
- Remove Linux implementation specific comment from binding document
- Force debugfs '0' to shutdown co-processor - rather than !1
- Supply more detailed commit message
- Propagate errors back from .stop()
- Review GPL wording
- Supply original author's SoBs
Lee Jones (7):
remoteproc: debugfs: Check of invalid 'count' value
remoteproc: dt: Provide bindings for ST's Remote Processor Controller
driver
remoteproc: debugfs: Add ability to boot remote processor using
debugfs
remoteproc: Supply controller driver for ST's Remote Processors
MAINTAINERS: Add ST's Remote Processor Driver to ARM/STI ARCHITECTURE
ARM: STiH407: Add nodes for RemoteProc
ARM: STiH407: Move over to using the 'reserved-memory' API for
obtaining DMA memory
.../devicetree/bindings/remoteproc/st-rproc.txt | 41 +++
MAINTAINERS | 1 +
arch/arm/boot/dts/stih407-family.dtsi | 70 +++++
drivers/remoteproc/Kconfig | 9 +
drivers/remoteproc/Makefile | 1 +
drivers/remoteproc/remoteproc_debugfs.c | 38 ++-
drivers/remoteproc/st_remoteproc.c | 297 +++++++++++++++++++++
7 files changed, 455 insertions(+), 2 deletions(-)
create mode 100644 Documentation/devicetree/bindings/remoteproc/st-rproc.txt
create mode 100644 drivers/remoteproc/st_remoteproc.c
--
1.9.1
next reply other threads:[~2016-01-12 12:46 UTC|newest]
Thread overview: 24+ messages / expand[flat|nested] mbox.gz Atom feed top
2016-01-12 12:46 Lee Jones [this message]
2016-01-12 12:46 ` [PATCH v5 1/7] remoteproc: debugfs: Check of invalid 'count' value Lee Jones
2016-01-12 12:46 ` [PATCH v5 2/7] remoteproc: dt: Provide bindings for ST's Remote Processor Controller driver Lee Jones
2016-01-12 14:33 ` Rob Herring
2016-01-12 14:46 ` Lee Jones
2016-03-16 16:39 ` [STLinux Kernel] " Peter Griffin
2016-01-12 12:46 ` [PATCH v5 3/7] remoteproc: debugfs: Add ability to boot remote processor using debugfs Lee Jones
2016-03-16 16:44 ` [STLinux Kernel] " Peter Griffin
2016-01-12 12:46 ` [PATCH v5 4/7] remoteproc: Supply controller driver for ST's Remote Processors Lee Jones
2016-01-12 14:47 ` Lee Jones
2016-03-16 16:38 ` [STLinux Kernel] " Peter Griffin
2016-01-12 12:46 ` [PATCH v5 5/7] MAINTAINERS: Add ST's Remote Processor Driver to ARM/STI ARCHITECTURE Lee Jones
2016-03-16 16:40 ` [STLinux Kernel] " Peter Griffin
2016-01-12 12:46 ` [PATCH v5 6/7] ARM: STiH407: Add nodes for RemoteProc Lee Jones
2016-04-13 22:04 ` Olof Johansson
2016-01-12 12:46 ` [PATCH v5 7/7] ARM: STiH407: Move over to using the 'reserved-memory' API for obtaining DMA memory Lee Jones
2016-03-16 16:35 ` [STLinux Kernel] " Peter Griffin
2016-03-16 16:55 ` Lee Jones
2016-03-16 20:10 ` Peter Griffin
2016-03-17 9:05 ` Loic PALLARDY
2016-03-17 10:18 ` Lee Jones
2016-01-27 7:31 ` [PATCH v5 0/7] remoteproc: Add driver for STMicroelectronics platforms Lee Jones
2016-01-27 19:19 ` Bjorn Andersson
2016-03-02 15:43 ` Lee Jones
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1452602781-22424-1-git-send-email-lee.jones@linaro.org \
--to=lee.jones@linaro.org \
--cc=linux-arm-kernel@lists.infradead.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).