From mboxrd@z Thu Jan 1 00:00:00 1970 From: wens@csie.org (Chen-Yu Tsai) Date: Thu, 21 Jan 2016 13:26:38 +0800 Subject: [PATCH RFC 11/15] ARM: dts: sun8i: sina33: Enable hardware reset and HS-DDR for eMMC In-Reply-To: <1453354002-28366-1-git-send-email-wens@csie.org> References: <1453354002-28366-1-git-send-email-wens@csie.org> Message-ID: <1453354002-28366-12-git-send-email-wens@csie.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org mmc2 has a special pin for eMMC hardware reset, which is controllable from the controller. Add the "mmc-cap-hw-reset" property to denote that this controller supports this function, and the pins are actually used. Also increase the signal drive strength for mmc2 pins, for HS-DDR mode support. Signed-off-by: Chen-Yu Tsai --- arch/arm/boot/dts/sun8i-a33-sinlinx-sina33.dts | 3 +++ 1 file changed, 3 insertions(+) diff --git a/arch/arm/boot/dts/sun8i-a33-sinlinx-sina33.dts b/arch/arm/boot/dts/sun8i-a33-sinlinx-sina33.dts index 13ce68f06dd6..bd2a3beb4629 100644 --- a/arch/arm/boot/dts/sun8i-a33-sinlinx-sina33.dts +++ b/arch/arm/boot/dts/sun8i-a33-sinlinx-sina33.dts @@ -109,10 +109,13 @@ vmmc-supply = <®_vcc3v0>; bus-width = <8>; non-removable; + cap-mmc-hw-reset; status = "okay"; }; &mmc2_8bit_pins { + /* Increase drive strength for DDR modes */ + allwinner,drive = ; /* eMMC is missing pull-ups */ allwinner,pull = ; }; -- 2.7.0.rc3