From: alex.williamson@redhat.com (Alex Williamson)
To: linux-arm-kernel@lists.infradead.org
Subject: [PATCH] vfio: pci: fix oops in case of vfio_msi_set_vector_signal failure
Date: Mon, 01 Feb 2016 14:34:38 -0700 [thread overview]
Message-ID: <1454362478.10542.8.camel@redhat.com> (raw)
In-Reply-To: <56AF9585.1000904@linaro.org>
On Mon, 2016-02-01 at 18:27 +0100, Eric Auger wrote:
> Hi Alex,
> On 01/29/2016 10:41 PM, Alex Williamson wrote:
> > On Fri, 2016-01-29 at 14:43 +0000, Eric Auger wrote:
> > > In case vfio_msi_set_vector_signal fails we tear down everything.
> > > In the tear down loop we compare int j against unsigned start. Given
> > > the arithmetic conversion I think it is converted into an unsigned and
> > > becomes 0xffffffff, leading to the loop being entered again and things
> > > turn bad when accessing vdev->msix[vector].vector. So let's use int
> > > parameters instead.
> > > ?
> > > Signed-off-by: Eric Auger <eric.auger@linaro.org>
> > > ---
> > > ?drivers/vfio/pci/vfio_pci_intrs.c | 4 ++--
> > > ?1 file changed, 2 insertions(+), 2 deletions(-)
> > > ?
> > > diff --git a/drivers/vfio/pci/vfio_pci_intrs.c b/drivers/vfio/pci/vfio_pci_intrs.c
> > > index 3b3ba15..510c48d 100644
> > > --- a/drivers/vfio/pci/vfio_pci_intrs.c
> > > +++ b/drivers/vfio/pci/vfio_pci_intrs.c
> > > @@ -374,8 +374,8 @@ static int vfio_msi_set_vector_signal(struct vfio_pci_device *vdev,
> > > ? return 0;
> > > ?}
> > > ?
> > > -static int vfio_msi_set_block(struct vfio_pci_device *vdev, unsigned start,
> > > - ??????unsigned count, int32_t *fds, bool msix)
> > > +static int vfio_msi_set_block(struct vfio_pci_device *vdev, int start,
> > > + ??????int count, int32_t *fds, bool msix)
> > > ?{
> > > ? int i, j, ret = 0;
> > > ?
> >?
> > Nice find, I don't think that's the only bug there though.??If @start is
> > -1 (UINT32_MAX) and @count is 1, then @j gets set to -1 in the setup and
> > we hit the same index dereference problem.??What if we did this instead:
> >?
> > diff --git a/drivers/vfio/pci/vfio_pci_intrs.c b/drivers/vfio/pci/vfio_pci_intrs.c
> > index 3b3ba15..2ae84ad 100644
> > --- a/drivers/vfio/pci/vfio_pci_intrs.c
> > +++ b/drivers/vfio/pci/vfio_pci_intrs.c
> > @@ -309,14 +309,14 @@ static int vfio_msi_set_vector_signal(struct vfio_pci_device *vdev,
> > ? ??????int vector, int fd, bool msix)
> > ?{
> > ? struct pci_dev *pdev = vdev->pdev;
> > - int irq = msix ? vdev->msix[vector].vector : pdev->irq + vector;
> > - char *name = msix ? "vfio-msix" : "vfio-msi";
> > ? struct eventfd_ctx *trigger;
> > - int ret;
> > + int irq, ret;
> > ?
> > - if (vector >= vdev->num_ctx)
> > + if (vector < 0 || vector >= vdev->num_ctx)
> > ? return -EINVAL;
> > ?
> > + irq = msix ? vdev->msix[vector].vector : pdev->irq + vector;
> > +
> > ? if (vdev->ctx[vector].trigger) {
> > ? free_irq(irq, vdev->ctx[vector].trigger);
> > ? irq_bypass_unregister_producer(&vdev->ctx[vector].producer);
> > @@ -328,8 +328,9 @@ static int vfio_msi_set_vector_signal(struct vfio_pci_device *vdev,
> > ? if (fd < 0)
> > ? return 0;
> > ?
> > - vdev->ctx[vector].name = kasprintf(GFP_KERNEL, "%s[%d](%s)",
> > - ???name, vector, pci_name(pdev));
> > + vdev->ctx[vector].name = kasprintf(GFP_KERNEL, "vfio-msi%s[%d](%s)",
> > + ???msix ? "x" : "", vector,
> > + ???pci_name(pdev));
> > ? if (!vdev->ctx[vector].name)
> > ? return -ENOMEM;
> > ?
> > @@ -379,7 +380,7 @@ static int vfio_msi_set_block(struct vfio_pci_device *vdev, unsigned start,
> > ?{
> > ? int i, j, ret = 0;
> > ?
> > - if (start + count > vdev->num_ctx)
> > + if (start >= vdev->num_ctx || start + count > vdev->num_ctx)
> > ? return -EINVAL;
> > ?
> > ? for (i = 0, j = start; i < count && !ret; i++, j++) {
> > @@ -388,7 +389,7 @@ static int vfio_msi_set_block(struct vfio_pci_device *vdev, unsigned start,
> > ? }
> > ?
> > ? if (ret) {
> > - for (--j; j >= start; j--)
> > + for (--j; j >= 0 && j >= start; j--)
> > ? vfio_msi_set_vector_signal(vdev, j, -1, msix);
> > ? }
> > ?
> >?
> > So we fix the problem with vfio_msi_set_vector_signal() dereferencing
> > the array before it validates the index (even though it shouldn't be
> > able to get there anymore), and then we do a better job of verifying
> > start and count (comparing to num_ctx will use unsigned even though
> > num_ctx itself is signed) and finally explicitly test the <0 case, which
> > I suppose we could also do by casting start at that point (we know it's
> > within the bounds of a signed integer given the previous tests).
>?
> Yes it looks OK to me.
>?
> I guess you submit? I will test it.
Yep, I'll post a real patch.??Thanks,
Alex
prev parent reply other threads:[~2016-02-01 21:34 UTC|newest]
Thread overview: 4+ messages / expand[flat|nested] mbox.gz Atom feed top
2016-01-29 14:43 [PATCH] vfio: pci: fix oops in case of vfio_msi_set_vector_signal failure Eric Auger
2016-01-29 21:41 ` Alex Williamson
2016-02-01 17:27 ` Eric Auger
2016-02-01 21:34 ` Alex Williamson [this message]
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1454362478.10542.8.camel@redhat.com \
--to=alex.williamson@redhat.com \
--cc=linux-arm-kernel@lists.infradead.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).