From mboxrd@z Thu Jan 1 00:00:00 1970 From: vishnupatekar0510@gmail.com (Vishnu Patekar) Date: Sat, 5 Mar 2016 23:43:02 +0800 Subject: [PATCH v3 09/13] ARM: dts: sun8i-a83t: Add RSB controller device node to dtsi In-Reply-To: <1457192586-25596-1-git-send-email-vishnupatekar0510@gmail.com> References: <1457192586-25596-1-git-send-email-vishnupatekar0510@gmail.com> Message-ID: <1457192586-25596-10-git-send-email-vishnupatekar0510@gmail.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org This patch adds a device node for the Reduced Serial Bus (RSB) controller and the defacto pinmux setting to the A83T dtsi. Since there is only one possible pinmux setting for RSB, just set it in the dtsi. Signed-off-by: Vishnu Patekar --- arch/arm/boot/dts/sun8i-a83t.dtsi | 21 +++++++++++++++++++++ 1 file changed, 21 insertions(+) diff --git a/arch/arm/boot/dts/sun8i-a83t.dtsi b/arch/arm/boot/dts/sun8i-a83t.dtsi index 5d240b9..7b02d85 100644 --- a/arch/arm/boot/dts/sun8i-a83t.dtsi +++ b/arch/arm/boot/dts/sun8i-a83t.dtsi @@ -476,6 +476,27 @@ interrupt-controller; #interrupt-cells = <3>; #gpio-cells = <3>; + + r_rsb_pins: r_rsb { + allwinner,pins = "PL0", "PL1"; + allwinner,function = "s_rsb"; + allwinner,drive = ; + allwinner,pull = ; + }; + }; + + r_rsb: i2c at 01f03400 { + compatible = "allwinner,sun8i-a23-rsb"; + reg = <0x01f03400 0x400>; + interrupts = ; + clocks = <&apb0_gates 3>; + clock-frequency = <3000000>; + resets = <&apb0_reset 3>; + pinctrl-names = "default"; + pinctrl-0 = <&r_rsb_pins>; + status = "disabled"; + #address-cells = <1>; + #size-cells = <0>; }; }; }; -- 1.9.1