From mboxrd@z Thu Jan 1 00:00:00 1970 From: hdegoede@redhat.com (Hans de Goede) Date: Sat, 14 May 2016 14:45:05 +0200 Subject: [PATCH v2 2/2] musb: sunxi: Set state to A_WAIT_VRISE when enabling Vbus In-Reply-To: <1463229905-26387-1-git-send-email-hdegoede@redhat.com> References: <1463229905-26387-1-git-send-email-hdegoede@redhat.com> Message-ID: <1463229905-26387-2-git-send-email-hdegoede@redhat.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org When the board is powering attached usb devices via the otg port sometimes / on some devices it takes slightly too long for the Vbus detection code in phy-sun4i-usb.c to signal that Vbus is high after enabling Vbus and the musb hardware signals a MUSB_INTR_VBUSERROR interrupt. This commit sets the otg state to A_WAIT_VRISE upon enabling Vbus making musb_stage0_irq() ignore the first VBUSERR_RETRY_COUNT VBUSERROR interrupts, fixing connection issues in these cases. Signed-off-by: Hans de Goede --- Changes in v2: -Use curly-braces in both branches of if-else --- drivers/usb/musb/sunxi.c | 9 ++++++--- 1 file changed, 6 insertions(+), 3 deletions(-) diff --git a/drivers/usb/musb/sunxi.c b/drivers/usb/musb/sunxi.c index 2c33d9b..e7d4617 100644 --- a/drivers/usb/musb/sunxi.c +++ b/drivers/usb/musb/sunxi.c @@ -112,7 +112,7 @@ static void sunxi_musb_work(struct work_struct *work) if (test_bit(SUNXI_MUSB_FL_HOSTMODE, &glue->flags)) { set_bit(SUNXI_MUSB_FL_VBUS_ON, &glue->flags); musb->xceiv->otg->default_a = 1; - musb->xceiv->otg->state = OTG_STATE_A_IDLE; + musb->xceiv->otg->state = OTG_STATE_A_WAIT_VRISE; MUSB_HST_MODE(musb); devctl |= MUSB_DEVCTL_SESSION; } else { @@ -145,10 +145,12 @@ static void sunxi_musb_set_vbus(struct musb *musb, int is_on) { struct sunxi_glue *glue = dev_get_drvdata(musb->controller->parent); - if (is_on) + if (is_on) { set_bit(SUNXI_MUSB_FL_VBUS_ON, &glue->flags); - else + musb->xceiv->otg->state = OTG_STATE_A_WAIT_VRISE; + } else { clear_bit(SUNXI_MUSB_FL_VBUS_ON, &glue->flags); + } schedule_work(&glue->work); } @@ -325,6 +327,7 @@ static int sunxi_set_mode(struct musb *musb, u8 mode) set_bit(SUNXI_MUSB_FL_PHY_ON, &glue->flags); /* Stop musb work from turning vbus off again */ set_bit(SUNXI_MUSB_FL_VBUS_ON, &glue->flags); + musb->xceiv->otg->state = OTG_STATE_A_WAIT_VRISE; } return 0; -- 2.7.4