[PATCH v4 0/4] Thermal: Support for hardware-tracked trip points

[PATCH v4 0/4] Thermal: Support for hardware-tracked trip points

[Caesar Wang]

The history patches come from Mikko and Sascha.
    http://thread.gmane.org/gmane.linux.power-management.general/59451

Now, I pick them up to continue upstream.
Nevermind!

This series history patches:
v3: https://lkml.org/lkml/2016/5/24/797
v2: https://lkml.org/lkml/2016/5/3/220
v1: https://lkml.org/lkml/2016/4/24/227

This series adds support for hardware trip points. It picks up earlier
work from Mikko Perttunen. Mikko implemented hardware trip points as part
of the device tree support. It was suggested back then to move the
functionality to the thermal core instead of putting more code into the
device tree support. This series does exactly that.

This series patches rebase the conflicts.
Note that the hardware-tracked trip points are very well tested currently.

Verified and tested on https://github.com/Caesar-github/rockchip/tree/wip/fixes-thermal-0525
That's based on linux-kernel 20160524.


Changes in v4:
- as the Javi comments, %s/implemnets/implements.

Changes in v3:
- as the Javi comments on https://patchwork.kernel.org/patch/9001311/.
- add the select if they set the option for devicetree.
- Add the peter's ACK.

Changes in v2:
- add the commit in patch[v2 2/5].
- Update the commit for patch[v2 4/5].

Caesar Wang (1):
  thermal: rockchip: add the set_trips function

Sascha Hauer (3):
  thermal: of: implement .set_trips for device tree thermal zones
  thermal: streamline get_trend callbacks
  thermal: bang-bang governor: act on lower trip boundary

 drivers/thermal/gov_bang_bang.c                    |  2 +-
 drivers/thermal/of-thermal.c                       | 30 +++++++++++------
 drivers/thermal/rockchip_thermal.c                 | 39 ++++++++++++++++++++++
 drivers/thermal/ti-soc-thermal/ti-thermal-common.c | 25 +++++---------
 include/linux/thermal.h                            |  6 +++-
 5 files changed, 73 insertions(+), 29 deletions(-)

-- 
1.9.1

[PATCH v4 4/4] thermal: rockchip: add the set_trips function

[Caesar Wang]

Whenever the current temperature is updated, the trip points immediately
below and above the current temperature are found. A sensor driver
callback `set_trips' is then called with the temperatures.
Lastly, The sensor will trigger the hardware high temperature interrupts
to increase the sampleing rate and throttle frequency to limit the
temperature rising When performing passive cooling.

Signed-off-by: Caesar Wang <wxt@rock-chips.com>
Cc: Zhang Rui <rui.zhang@intel.com>
Cc: Eduardo Valentin <edubezval@gmail.com>
Cc: linux-pm at vger.kernel.org

---

Changes in v4: None
Changes in v3: None
Changes in v2: None

 drivers/thermal/rockchip_thermal.c | 39 ++++++++++++++++++++++++++++++++++++++
 1 file changed, 39 insertions(+)

diff --git a/drivers/thermal/rockchip_thermal.c b/drivers/thermal/rockchip_thermal.c
index 86a1ab0..39e2eec 100644
--- a/drivers/thermal/rockchip_thermal.c
+++ b/drivers/thermal/rockchip_thermal.c
@@ -96,6 +96,7 @@ struct chip_tsadc_table {
  * @initialize: SoC special initialize tsadc controller method
  * @irq_ack: clear the interrupt
  * @get_temp: get the temperature
+ * @set_alarm_temp: set the high temperature interrupt
  * @set_tshut_temp: set the hardware-controlled shutdown temperature
  * @set_tshut_mode: set the hardware-controlled shutdown mode
  * @table: the chip-specific conversion table
@@ -119,6 +120,8 @@ struct rockchip_tsadc_chip {
 	/* Per-sensor methods */
 	int (*get_temp)(struct chip_tsadc_table table,
 			int chn, void __iomem *reg, int *temp);
+	void (*set_alarm_temp)(struct chip_tsadc_table table,
+			       int chn, void __iomem *reg, int temp);
 	void (*set_tshut_temp)(struct chip_tsadc_table table,
 			       int chn, void __iomem *reg, int temp);
 	void (*set_tshut_mode)(int chn, void __iomem *reg, enum tshut_mode m);
@@ -183,6 +186,7 @@ struct rockchip_thermal_data {
 #define TSADCV2_INT_EN				0x08
 #define TSADCV2_INT_PD				0x0c
 #define TSADCV2_DATA(chn)			(0x20 + (chn) * 0x04)
+#define TSADCV2_COMP_INT(chn)		        (0x30 + (chn) * 0x04)
 #define TSADCV2_COMP_SHUT(chn)		        (0x40 + (chn) * 0x04)
 #define TSADCV2_HIGHT_INT_DEBOUNCE		0x60
 #define TSADCV2_HIGHT_TSHUT_DEBOUNCE		0x64
@@ -628,6 +632,20 @@ static int rk_tsadcv2_get_temp(struct chip_tsadc_table table,
 	return rk_tsadcv2_code_to_temp(table, val, temp);
 }
 
+static void rk_tsadcv2_alarm_temp(struct chip_tsadc_table table,
+				  int chn, void __iomem *regs, int temp)
+{
+	u32 alarm_value, int_en;
+
+	alarm_value = rk_tsadcv2_temp_to_code(table, temp);
+	writel_relaxed(alarm_value & table.data_mask,
+		       regs + TSADCV2_COMP_INT(chn));
+
+	int_en = readl_relaxed(regs + TSADCV2_INT_EN);
+	int_en |= TSADCV2_INT_SRC_EN(chn);
+	writel_relaxed(int_en, regs + TSADCV2_INT_EN);
+}
+
 static void rk_tsadcv2_tshut_temp(struct chip_tsadc_table table,
 				  int chn, void __iomem *regs, int temp)
 {
@@ -670,6 +688,7 @@ static const struct rockchip_tsadc_chip rk3228_tsadc_data = {
 	.irq_ack = rk_tsadcv3_irq_ack,
 	.control = rk_tsadcv3_control,
 	.get_temp = rk_tsadcv2_get_temp,
+	.set_alarm_temp = rk_tsadcv2_alarm_temp,
 	.set_tshut_temp = rk_tsadcv2_tshut_temp,
 	.set_tshut_mode = rk_tsadcv2_tshut_mode,
 
@@ -694,6 +713,7 @@ static const struct rockchip_tsadc_chip rk3288_tsadc_data = {
 	.irq_ack = rk_tsadcv2_irq_ack,
 	.control = rk_tsadcv2_control,
 	.get_temp = rk_tsadcv2_get_temp,
+	.set_alarm_temp = rk_tsadcv2_alarm_temp,
 	.set_tshut_temp = rk_tsadcv2_tshut_temp,
 	.set_tshut_mode = rk_tsadcv2_tshut_mode,
 
@@ -718,6 +738,7 @@ static const struct rockchip_tsadc_chip rk3366_tsadc_data = {
 	.irq_ack = rk_tsadcv3_irq_ack,
 	.control = rk_tsadcv3_control,
 	.get_temp = rk_tsadcv2_get_temp,
+	.set_alarm_temp = rk_tsadcv2_alarm_temp,
 	.set_tshut_temp = rk_tsadcv2_tshut_temp,
 	.set_tshut_mode = rk_tsadcv2_tshut_mode,
 
@@ -742,6 +763,7 @@ static const struct rockchip_tsadc_chip rk3368_tsadc_data = {
 	.irq_ack = rk_tsadcv2_irq_ack,
 	.control = rk_tsadcv2_control,
 	.get_temp = rk_tsadcv2_get_temp,
+	.set_alarm_temp = rk_tsadcv2_alarm_temp,
 	.set_tshut_temp = rk_tsadcv2_tshut_temp,
 	.set_tshut_mode = rk_tsadcv2_tshut_mode,
 
@@ -766,6 +788,7 @@ static const struct rockchip_tsadc_chip rk3399_tsadc_data = {
 	.irq_ack = rk_tsadcv3_irq_ack,
 	.control = rk_tsadcv3_control,
 	.get_temp = rk_tsadcv2_get_temp,
+	.set_alarm_temp = rk_tsadcv2_alarm_temp,
 	.set_tshut_temp = rk_tsadcv2_tshut_temp,
 	.set_tshut_mode = rk_tsadcv2_tshut_mode,
 
@@ -826,6 +849,21 @@ static irqreturn_t rockchip_thermal_alarm_irq_thread(int irq, void *dev)
 	return IRQ_HANDLED;
 }
 
+static int rockchip_thermal_set_trips(void *_sensor, int low, int high)
+{
+	struct rockchip_thermal_sensor *sensor = _sensor;
+	struct rockchip_thermal_data *thermal = sensor->thermal;
+	const struct rockchip_tsadc_chip *tsadc = thermal->chip;
+
+	dev_dbg(&thermal->pdev->dev, "%s: sensor %d: low: %d, high %d\n",
+		__func__, sensor->id, low, high);
+
+	tsadc->set_alarm_temp(tsadc->table,
+			      sensor->id, thermal->regs, high);
+
+	return 0;
+}
+
 static int rockchip_thermal_get_temp(void *_sensor, int *out_temp)
 {
 	struct rockchip_thermal_sensor *sensor = _sensor;
@@ -843,6 +881,7 @@ static int rockchip_thermal_get_temp(void *_sensor, int *out_temp)
 
 static const struct thermal_zone_of_device_ops rockchip_of_thermal_ops = {
 	.get_temp = rockchip_thermal_get_temp,
+	.set_trips = rockchip_thermal_set_trips,
 };
 
 static int rockchip_configure_from_dt(struct device *dev,
-- 
1.9.1

[PATCH v4 0/4] Thermal: Support for hardware-tracked trip points

[Caesar Wang]

Forget to send a patch, sorry for the noise.:-(
Please ignore this series patches [PATCH v4 0/4].

RESEND the new series patches "[RESEND PATCH v4 0/5]".

On 2016?05?27? 16:23, Caesar Wang wrote:
> The history patches come from Mikko and Sascha.
>      http://thread.gmane.org/gmane.linux.power-management.general/59451
>
> Now, I pick them up to continue upstream.
> Nevermind!
>
> This series history patches:
> v3: https://lkml.org/lkml/2016/5/24/797
> v2: https://lkml.org/lkml/2016/5/3/220
> v1: https://lkml.org/lkml/2016/4/24/227
>
> This series adds support for hardware trip points. It picks up earlier
> work from Mikko Perttunen. Mikko implemented hardware trip points as part
> of the device tree support. It was suggested back then to move the
> functionality to the thermal core instead of putting more code into the
> device tree support. This series does exactly that.
>
> This series patches rebase the conflicts.
> Note that the hardware-tracked trip points are very well tested currently.
>
> Verified and tested on https://github.com/Caesar-github/rockchip/tree/wip/fixes-thermal-0525
> That's based on linux-kernel 20160524.
>
>
> Changes in v4:
> - as the Javi comments, %s/implemnets/implements.
>
> Changes in v3:
> - as the Javi comments on https://patchwork.kernel.org/patch/9001311/.
> - add the select if they set the option for devicetree.
> - Add the peter's ACK.
>
> Changes in v2:
> - add the commit in patch[v2 2/5].
> - Update the commit for patch[v2 4/5].
>
> Caesar Wang (1):
>    thermal: rockchip: add the set_trips function
>
> Sascha Hauer (3):
>    thermal: of: implement .set_trips for device tree thermal zones
>    thermal: streamline get_trend callbacks
>    thermal: bang-bang governor: act on lower trip boundary
>
>   drivers/thermal/gov_bang_bang.c                    |  2 +-
>   drivers/thermal/of-thermal.c                       | 30 +++++++++++------
>   drivers/thermal/rockchip_thermal.c                 | 39 ++++++++++++++++++++++
>   drivers/thermal/ti-soc-thermal/ti-thermal-common.c | 25 +++++---------
>   include/linux/thermal.h                            |  6 +++-
>   5 files changed, 73 insertions(+), 29 deletions(-)
>