[PATCH v3 RESEND 3/7] binding: mdio-mux: Add DT binding doc for Broadcom MDIO bus mutiplexer

[pramod.kumar@broadcom.com (Pramod Kumar)]

Add DT binding doc for Broadcom MDIO bus mutiplexer driver.

Signed-off-by: Pramod Kumar <pramod.kumar@broadcom.com>
---
 .../bindings/net/brcm,mdio-mux-iproc.txt           | 59 ++++++++++++++++++++++
 1 file changed, 59 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/net/brcm,mdio-mux-iproc.txt

diff --git a/Documentation/devicetree/bindings/net/brcm,mdio-mux-iproc.txt b/Documentation/devicetree/bindings/net/brcm,mdio-mux-iproc.txt
new file mode 100644
index 0000000..7c53278
--- /dev/null
+++ b/Documentation/devicetree/bindings/net/brcm,mdio-mux-iproc.txt
@@ -0,0 +1,59 @@
+Properties for an MDIO bus mutiplexer found in Broadcom iProc based SoCs.
+
+This MDIO bus multiplexer defines buses that could be internal as well as
+external to SoCs and could accept MDIO transaction compatible to C-22 or
+C-45 Clause. When child bus is selected, one needs to select these two
+properties as well to generate desired MDIO trascation on appropriate bus.
+
+Required properties in addition to the generic multiplexer properties:
+
+MDIO multiplexer node:
+- compatible: brcm,mdio-mux-iproc.
+
+Every non-ethernet PHY requires a compatible so that it could be probed based
+on this compatible string.
+
+Additional information regarding generic multiplexer properties can be found
+at- Documentation/devicetree/bindings/net/mdio-mux.txt
+
+
+for example:
+		mdio_mux_iproc: mdio-mux at 6602023c {
+			compatible = "brcm,mdio-mux-iproc";
+			reg = <0x6602023c 0x14>;
+			#address-cells = <1>;
+			#size-cells = <0>;
+
+			mdio at 0 {
+				reg = <0x0>;
+				#address-cells = <1>;
+				#size-cells = <0>;
+
+				pci_phy0: pci-phy at 0 {
+					compatible = "brcm,ns2-pcie-phy";
+					reg = <0x0>;
+					#phy-cells = <0>;
+				};
+			};
+
+			mdio at 7 {
+				reg = <0x7>;
+				#address-cells = <1>;
+				#size-cells = <0>;
+
+				pci_phy1: pci-phy at 0 {
+					compatible = "brcm,ns2-pcie-phy";
+					reg = <0x0>;
+					#phy-cells = <0>;
+				};
+			};
+			mdio at 10 {
+				reg = <0x10>;
+				#address-cells = <1>;
+				#size-cells = <0>;
+
+				gphy0: eth-phy at 10 {
+					reg = <0x10>;
+				};
+			};
+		};
-- 
1.9.1