From mboxrd@z Thu Jan 1 00:00:00 1970 From: peter.griffin@linaro.org (Peter Griffin) Date: Wed, 14 Sep 2016 14:27:46 +0100 Subject: [PATCH 08/19] thermal: sti: Remove obsolete platforms from the DT doc. In-Reply-To: <1473859677-9231-1-git-send-email-peter.griffin@linaro.org> References: <1473859677-9231-1-git-send-email-peter.griffin@linaro.org> Message-ID: <1473859677-9231-9-git-send-email-peter.griffin@linaro.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org STiH415/6 SoC's are being removed from the kernel. This patch removes the compatibles from the dt doc and also updates the example to a supported platform. Signed-off-by: Peter Griffin Cc: Cc: Cc: --- .../devicetree/bindings/thermal/st-thermal.txt | 28 +++++++--------------- 1 file changed, 9 insertions(+), 19 deletions(-) diff --git a/Documentation/devicetree/bindings/thermal/st-thermal.txt b/Documentation/devicetree/bindings/thermal/st-thermal.txt index 3b9251b..a2f9391 100644 --- a/Documentation/devicetree/bindings/thermal/st-thermal.txt +++ b/Documentation/devicetree/bindings/thermal/st-thermal.txt @@ -3,17 +3,8 @@ Binding for Thermal Sensor driver for STMicroelectronics STi series of SoCs. Required parameters: ------------------- -compatible : st,--thermal; should be one of: - "st,stih415-sas-thermal", - "st,stih415-mpe-thermal", - "st,stih416-sas-thermal" - "st,stih416-mpe-thermal" - "st,stid127-thermal" or - "st,stih407-thermal" - according to the SoC type (stih415, stih416, stid127, stih407) - and module type (sas or mpe). On stid127 & stih407 there is only - one die/module, so there is no module type in the compatible - string. +compatible : Should be "st,stih407-thermal" + clock-names : Should be "thermal". See: Documentation/devicetree/bindings/resource-names.txt clocks : Phandle of the clock used by the thermal sensor. @@ -25,18 +16,17 @@ Optional parameters: reg : For non-sysconf based sensors, this should be the physical base address and length of the sensor's registers. interrupts : Standard way to define interrupt number. - Interrupt is mandatory to be defined when compatible is - "stih416-mpe-thermal". NB: For thermal sensor's for which no interrupt has been defined, a polling delay of 1000ms will be used to read the temperature from device. Example: - temp1 at fdfe8000 { - compatible = "st,stih416-mpe-thermal"; - reg = <0xfdfe8000 0x10>; - clock-names = "thermal"; - clocks = <&clk_m_mpethsens>; - interrupts = ; + temp0 at 91a0000 { + compatible = "st,stih407-thermal"; + reg = <0x91a0000 0x28>; + clock-names = "thermal"; + clocks = <&CLK_SYSIN>; + interrupts = ; + st,passive_cooling_temp = <110>; }; -- 1.9.1