From mboxrd@z Thu Jan 1 00:00:00 1970 From: nicolae.rosia.oss@gmail.com (Nicolae Rosia) Date: Tue, 4 Oct 2016 15:46:17 +0300 Subject: [PATCH 2/2] tty: serial: Makefile: move kgdb to be initialized last In-Reply-To: <1475585177-28777-1-git-send-email-nicolae.rosia.oss@gmail.com> References: <1475585177-28777-1-git-send-email-nicolae.rosia.oss@gmail.com> Message-ID: <1475585177-28777-3-git-send-email-nicolae.rosia.oss@gmail.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org From: Nicolae Rosia fsl_lpuart cannot be used with kgdb because the kgdb initcall is called before the driver's init. Move kgdb to be initialized after all serial drivers have been inited. Signed-off-by: Nicolae Rosia Signed-off-by: Stefan Golinschi --- drivers/tty/serial/Makefile | 5 +++-- 1 file changed, 3 insertions(+), 2 deletions(-) diff --git a/drivers/tty/serial/Makefile b/drivers/tty/serial/Makefile index 1278d37..8016ef9 100644 --- a/drivers/tty/serial/Makefile +++ b/drivers/tty/serial/Makefile @@ -62,13 +62,11 @@ obj-$(CONFIG_SERIAL_ATMEL) += atmel_serial.o obj-$(CONFIG_SERIAL_UARTLITE) += uartlite.o obj-$(CONFIG_SERIAL_MSM) += msm_serial.o obj-$(CONFIG_SERIAL_NETX) += netx-serial.o -obj-$(CONFIG_SERIAL_KGDB_NMI) += kgdb_nmi.o obj-$(CONFIG_SERIAL_KS8695) += serial_ks8695.o obj-$(CONFIG_SERIAL_OMAP) += omap-serial.o obj-$(CONFIG_SERIAL_ALTERA_UART) += altera_uart.o obj-$(CONFIG_SERIAL_ST_ASC) += st-asc.o obj-$(CONFIG_SERIAL_TILEGX) += tilegx.o -obj-$(CONFIG_KGDB_SERIAL_CONSOLE) += kgdboc.o obj-$(CONFIG_SERIAL_QE) += ucc_uart.o obj-$(CONFIG_SERIAL_TIMBERDALE) += timbuart.o obj-$(CONFIG_SERIAL_GRLIB_GAISLER_APBUART) += apbuart.o @@ -96,3 +94,6 @@ obj-$(CONFIG_SERIAL_MPS2_UART) += mps2-uart.o # GPIOLIB helpers for modem control lines obj-$(CONFIG_SERIAL_MCTRL_GPIO) += serial_mctrl_gpio.o + +obj-$(CONFIG_SERIAL_KGDB_NMI) += kgdb_nmi.o +obj-$(CONFIG_KGDB_SERIAL_CONSOLE) += kgdboc.o -- 2.5.5