From: stephen.boyd@linaro.org (Stephen Boyd)
To: linux-arm-kernel@lists.infradead.org
Subject: [PATCH v5 11/23] usb: chipidea: Emulate OTGSC interrupt enable path
Date: Fri, 21 Oct 2016 10:57:45 -0700 [thread overview]
Message-ID: <147707266552.25233.4203897094706565540@sboyd-linaro> (raw)
In-Reply-To: <20161021021450.GA16461@b29397-desktop>
Quoting Peter Chen (2016-10-20 19:14:50)
>
> I tested my patch, it works well at my side, if it is ok for you, please
> ack it, I will apply it as well as your chipidea series after your
> gpu fix patch at greg's usb-next tree.
Feel free to add my:
Tested-by: Stephen Boyd <stephen.boyd@linaro.org>
Reported-by: Stephen Boyd <stephen.boyd@linaro.org>
tags to the patch.
>
> Is it ok for you?
>
Ok sounds good. The GPU patch has been picked up into drm-misc now, but
I'm not sure if it's going to be merged into -rc2 or not but it sounds
like you'll figure that part out.
I'll resend the phy drivers to Kishon now. Thanks.
next prev parent reply other threads:[~2016-10-21 17:57 UTC|newest]
Thread overview: 54+ messages / expand[flat|nested] mbox.gz Atom feed top
2016-10-18 1:56 [PATCH v5 00/23] Support qcom's HSIC USB and rewrite USB2 HS support Stephen Boyd
2016-10-18 1:56 ` [PATCH v5 01/23] of: device: Support loading a module with OF based modalias Stephen Boyd
2016-10-18 1:56 ` [PATCH v5 02/23] of: device: Export of_device_{get_modalias, uvent_modalias} to modules Stephen Boyd
2016-10-18 5:20 ` Chen-Yu Tsai
2016-10-24 12:19 ` Chen-Yu Tsai
2016-10-24 19:48 ` Stephen Boyd
2016-10-25 1:16 ` Peter Chen
2016-11-04 20:51 ` Stephen Boyd
2016-11-07 1:29 ` Peter Chen
2016-11-07 1:56 ` Chen-Yu Tsai
2016-11-10 21:42 ` Rob Herring
2016-11-11 3:01 ` Chen-Yu Tsai
2016-11-11 4:25 ` Javier Martinez Canillas
2016-10-18 1:56 ` [PATCH v5 03/23] usb: ulpi: Support device discovery via DT Stephen Boyd
2016-10-18 16:44 ` Rob Herring
2016-11-11 11:02 ` Heikki Krogerus
2016-10-18 1:56 ` [PATCH v5 04/23] usb: chipidea: Only read/write OTGSC from one place Stephen Boyd
2016-10-18 1:56 ` [PATCH v5 05/23] usb: chipidea: Handle extcon events properly Stephen Boyd
2016-10-18 1:56 ` [PATCH v5 06/23] usb: chipidea: Add platform flag for wrapper phy management Stephen Boyd
2016-10-18 1:56 ` [PATCH v5 07/23] usb: chipidea: Notify events when switching host mode Stephen Boyd
2016-10-18 1:56 ` [PATCH v5 08/23] usb: chipidea: Remove locking in ci_udc_start() Stephen Boyd
2016-10-18 1:56 ` [PATCH v5 09/23] usb: chipidea: Add support for ULPI PHY bus Stephen Boyd
2016-10-18 1:56 ` [PATCH v5 10/23] usb: chipidea: Consolidate extcon notifiers Stephen Boyd
2016-10-18 1:56 ` [PATCH v5 11/23] usb: chipidea: Emulate OTGSC interrupt enable path Stephen Boyd
2016-10-19 1:15 ` Peter Chen
2016-10-19 1:53 ` Stephen Boyd
2016-10-19 8:02 ` Peter Chen
2016-10-20 6:55 ` Stephen Boyd
2016-10-20 10:10 ` Peter Chen
2016-10-20 20:36 ` Stephen Boyd
2016-10-21 2:14 ` Peter Chen
2016-10-21 17:57 ` Stephen Boyd [this message]
2016-10-18 1:56 ` [PATCH v5 12/23] usb: chipidea: msm: Mark device as runtime pm active Stephen Boyd
2016-10-18 1:56 ` [PATCH v5 13/23] usb: chipidea: msm: Rely on core to override AHBBURST Stephen Boyd
2016-10-18 1:56 ` [PATCH v5 14/23] usb: chipidea: msm: Use hw_write_id_reg() instead of writel Stephen Boyd
2016-10-18 1:56 ` [PATCH v5 15/23] usb: chipidea: msm: Add proper clk and reset support Stephen Boyd
2016-10-18 1:56 ` [PATCH v5 16/23] usb: chipidea: msm: Mux over secondary phy at the right time Stephen Boyd
2016-10-18 1:56 ` [PATCH v5 17/23] usb: chipidea: msm: Restore wrapper settings after reset Stephen Boyd
2016-10-18 1:56 ` [PATCH v5 18/23] usb: chipidea: msm: Make platform data driver local instead of global Stephen Boyd
2016-10-18 1:56 ` [PATCH v5 19/23] usb: chipidea: msm: Add reset controller for PHY POR bit Stephen Boyd
2016-10-18 1:56 ` [PATCH v5 20/23] usb: chipidea: msm: Handle phy power states Stephen Boyd
2016-10-18 1:56 ` [PATCH v5 21/23] usb: chipidea: msm: Be silent on probe defer errors Stephen Boyd
2016-10-18 1:56 ` [PATCH v5 22/23] phy: Add support for Qualcomm's USB HSIC phy Stephen Boyd
2016-10-18 1:56 ` [PATCH v5 23/23] phy: Add support for Qualcomm's USB HS phy Stephen Boyd
2016-10-18 16:46 ` Rob Herring
2016-10-18 16:47 ` Rob Herring
2016-10-20 23:20 ` Stephen Boyd
2016-10-21 2:20 ` Peter Chen
2016-10-21 19:33 ` Stephen Boyd
2016-10-24 2:14 ` Peter Chen
2016-10-18 9:31 ` [PATCH v5 00/23] Support qcom's HSIC USB and rewrite USB2 HS support Peter Chen
2016-10-18 20:51 ` Stephen Boyd
2016-11-11 7:40 ` Peter Chen
2016-11-14 19:35 ` Stephen Boyd
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=147707266552.25233.4203897094706565540@sboyd-linaro \
--to=stephen.boyd@linaro.org \
--cc=linux-arm-kernel@lists.infradead.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox