From mboxrd@z Thu Jan 1 00:00:00 1970 From: linus.walleij@linaro.org (Linus Walleij) Date: Thu, 3 Nov 2016 10:13:09 +0100 Subject: [PATCH 2/3] ARM: dts: reference PM8058 as IRQ parent In-Reply-To: <1478164390-21613-1-git-send-email-linus.walleij@linaro.org> References: <1478164390-21613-1-git-send-email-linus.walleij@linaro.org> Message-ID: <1478164390-21613-2-git-send-email-linus.walleij@linaro.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Some nodes are referencing the pm8058_gpio as IRQ parent, but the HW IRQ offset they are supplying is actually that for the parent to that controller: the PM8058 itself. Since that is the proper parent, reference it directly. We can switch this to the pm8058_gpio and the proper offset once we have fixed the SSBI GPIO driver to properly deal with the hierarchical IRQ domain and get proper local offset translation. Signed-off-by: Linus Walleij --- arch/arm/boot/dts/qcom-apq8060-dragonboard.dts | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-) diff --git a/arch/arm/boot/dts/qcom-apq8060-dragonboard.dts b/arch/arm/boot/dts/qcom-apq8060-dragonboard.dts index 4a532ddab53a..ea660ffa03ea 100644 --- a/arch/arm/boot/dts/qcom-apq8060-dragonboard.dts +++ b/arch/arm/boot/dts/qcom-apq8060-dragonboard.dts @@ -369,8 +369,8 @@ ak8975 at 0c { compatible = "asahi-kasei,ak8975"; reg = <0x0c>; - /* GPIO33 has interrupt 224 on the PM8058 */ - interrupt-parent = <&pm8058_gpio>; + /* FIXME: GPIO33 has interrupt 224 on the PM8058 */ + interrupt-parent = <&pm8058>; interrupts = <224 IRQ_TYPE_EDGE_RISING>; pinctrl-names = "default"; pinctrl-0 = <&dragon_ak8975_gpios>; @@ -380,8 +380,8 @@ bmp085 at 77 { compatible = "bosch,bmp085"; reg = <0x77>; - /* GPIO16 has interrupt 207 on the PM8058 */ - interrupt-parent = <&pm8058_gpio>; + /* FIXME: GPIO16 has interrupt 207 on the PM8058 */ + interrupt-parent = <&pm8058>; interrupts = <207 IRQ_TYPE_EDGE_RISING>; reset-gpios = <&tlmm 86 GPIO_ACTIVE_LOW>; pinctrl-names = "default"; -- 2.7.4