[PATCH v20 0/4] Mediatek MT8173 CMDQ support

[hs.liao@mediatek.com (Horng-Shyang Liao)]

On Fri, 2017-01-13 at 09:27 +0800, Horng-Shyang Liao wrote:
> On Wed, 2017-01-04 at 11:06 +0800, HS Liao wrote:
> > Hi,
> > 
> > This is Mediatek MT8173 Command Queue(CMDQ) driver. The CMDQ is used
> > to help write registers with critical time limitation, such as
> > updating display configuration during the vblank. It controls Global
> > Command Engine (GCE) hardware to achieve this requirement.
> > 
> > These patches have a build dependency on top of v4.10-rc2.
> > 
> > Changes since v19:
> >  - rebase to v4.10-rc2
> > 
> > Best regards,
> > HS Liao
> > 
> > HS Liao (4):
> >   dt-bindings: soc: Add documentation for the MediaTek GCE unit
> >   mailbox: mediatek: Add Mediatek CMDQ driver
> >   arm64: dts: mt8173: Add GCE node
> >   soc: mediatek: Add Mediatek CMDQ helper
> > 
> >  .../devicetree/bindings/mailbox/mtk-gce.txt        |  43 ++
> >  arch/arm64/boot/dts/mediatek/mt8173.dtsi           |  10 +
> >  drivers/mailbox/Kconfig                            |  10 +
> >  drivers/mailbox/Makefile                           |   2 +
> >  drivers/mailbox/mtk-cmdq-mailbox.c                 | 596 +++++++++++++++++++++
> >  drivers/soc/mediatek/Kconfig                       |  12 +
> >  drivers/soc/mediatek/Makefile                      |   1 +
> >  drivers/soc/mediatek/mtk-cmdq-helper.c             | 310 +++++++++++
> >  include/linux/mailbox/mtk-cmdq-mailbox.h           |  75 +++
> >  include/linux/soc/mediatek/mtk-cmdq.h              | 174 ++++++
> >  10 files changed, 1233 insertions(+)
> >  create mode 100644 Documentation/devicetree/bindings/mailbox/mtk-gce.txt
> >  create mode 100644 drivers/mailbox/mtk-cmdq-mailbox.c
> >  create mode 100644 drivers/soc/mediatek/mtk-cmdq-helper.c
> >  create mode 100644 include/linux/mailbox/mtk-cmdq-mailbox.h
> >  create mode 100644 include/linux/soc/mediatek/mtk-cmdq.h
> > 
> 
> Hi Jassi, Matthias,
> 
> Sorry to disturb you.
> Do you have any further comments on CMDQ v20?
> 
> Thanks.
> HS

Hi Jassi, Matthias,

Sorry to disturb you again.
Do you have any further comments on CMDQ v20?

Thanks.
HS